User manual BARTSCHER 700455

[. . . ] All the information and instructions in this manual take into account standard safety regulations, current levels of technical engineering as well as the expertise and experience we have developed over the years. The instruction manual was translated with all due care and attention. If the delivery consists of a special model, the actual scope of delivery may differ from the descriptions and illustrations in this manual. This is also the case for special orders or when the device has been modified in line with new technology. [. . . ] Hidden damages should be reclaimed immediately after notice, as claims for damages can only be asserted within the effective period for complaints. Please do not throw away the covering carton of your device as it might be useful for storage purposes, when moving or, in case of damages, when the device must be sent back to a repair center. The outer and inner packing material should be removed completely from the device before installation. If you liked to dispose the packing, consider the regulations applicable in your country. In case any part is missing please contact our customer service center immediately. Keep the package closed until installation and under consideration of the outside indicated positioning- and storage markings. Packages should be stored under consideration of the following: Do not store outdoors. In case of longer storage (> 3 months) make sure you check the state of the packaging and the parts regularly. The device must only be connected to a properly installed single socket with protective contact. Do not use the device in case it does not function properly, has been damaged or dropped. Do not use any accessory or spare parts that have not been recommended by the manufacturer. These can be dangerous for the user or lead to damages of the device or personal injury, and further, the warranty expires. Keep away the cable from operating range and do not dunk it into water. Do not allow the water to be affected by rain, dripping water or other forms of moisture. Take caution not to damage any part of the cooling system (compressor, etc. If coolant does leak from the cooling system, remove the device's plug from the power source and call the customer service centre. Before installation the local power grid specification should be compared with that of the device (see type label). Raise the refrigerator using a pallet jack and place it where it is intended to be located. Do not push or pull the refrigerator as it may tilt, causing damage to the external casing and adjustable legs. When the refrigerator is placed in its intended location, remove the pallet. Every leg must touch the floor, as otherwise the door may open and close improperly. Not at any time should you place the device on an inflammable surface. [. . . ] The message E0 appears when one alarm is active, (temperature value is not displayed), and flashes when other alarm signals show or when the measurement value of the second sensor is displayed. The message will disappear when the next defrost cycle finished normally. Time being exceeded, and not because of normal end of cycle This is not an error message, but a message that the unit is in the middle of a defrost cycle. At the end of its service life the discarded device has to be disposed in accordance with the national regulations. [. . . ]