User manual BARTSCHER 500391

[. . . ] Before calling for service/assistance in the case of malfunction, consult the chapter entitled “Is There a Problem?Do not try to repair the problem by trying to access the internal components of the appliance. If damaged, the power supply cord on this appliance must necessarily be replaced by our service centre because special tools are required for replacement. Do not use electric appliances inside the compartment for food storage, if these are not those recommended by the manufacturer. [. . . ] the appliance is designed to be installed in a switched spur outlet fused at 13 Ampere. If the installation requires a 13 Ampere plug type to be fitted it should be conform to BSI 1363. 9 GB A closer look A Temperature regulation knob his knob is used to regulate the temperature in the two compartments with the following settings: C D E Removable miscellaneous shelf Compartment for a 2 litre bottle Removable door shelf for bottles Fruit and Vegetable Crisper Drain for Defrost Water Removable, Height-adjustable Shelves Compartment for storing frozen foods, freezing fresh foods and making ice The refrigerator is off; 1 less cold; 5 colder F G H I B Removable door shelves with lid, with egg tray and lidded butter dish A I B H C H H G F C D E GB 10 How to Start the Appliance NOTICE After the appliance has been delivered, stand it in the upright position and wait approximately 3 hours before connecting it to the electrical outlet to guarantee that it operates properly. Before placing foodstuffs in the refrigerator or freezer, clean the interior well with warm water and baking soda. After putting the plug in the socket, make sure that the light is on inside the appliance and then turn the thermostat knob (A) to the “3” setting. After a few hours have passed, you can place fresh food in the refrigerator compartment and frozen foods into the freezer. The thermostat automatically regulates the temperature inside the appliance 1 = less cold 5 = colder It is recommended that a medium setting be used. To increase the amount of space, optimize arrangement and improve appearance, this appliance has a “cooling area” located within the back panel of the refrigerator compartment. When the appliance is operating, this panel may be covered with frost or droplets of water depending on whether the compressor is operating or not at a given time. If the thermostat knob is positioned on higher settings while the refrigerator is heavily filled and the ambient temperature high, the appliance may run continuously, resulting in the formation of frost on the back cooling area. To avoid this situation, just turn the thermostat knob to a lower setting so that the appliance defrosts automatically. Tips on Saving Energy - Install the Appliance Properly In other words, away from sources of heat and direct sunlight, in a well ventilated room complying with the minimum distances indicated in the paragraph entitled, “ Installation/Ventilation. ” THE ACTUAL ENERGY CONSUMPTION OF THE APPLIANCE DEPENDS ON THE WAY THE SAME IS USED AND ON ITS LOCATION. The consumption tests were performed in 560mm deep column units, the most common installation setting for this appliance. - Use the Right Temperature Setting A setting which is too cold increases energy consumption. - Do not Overfill To conserve food properly, the cold air must circulate freely within the refrigerator. If it is overfilled, this will prevent proper air circulation, forcing the compressor to work continuously. - Close the Doors Open your refrigerator as little as possible because each time you do so you loose much of the cold air. To raise the temperature to the proper level again, the motor must work for a long time, consuming energy. - Keep an Eye on the Seals Keep the seals clean and make sure that they adhere well to the door. - No Hot Foods A hot pot or pan placed in the refrigerator immediately raises the temperature several degrees. Let hot cookware and food cool to ambient temperature before placing them in the refrigerator. [. . . ] However, to preserve this quality of your appliance, the food stored in it must be well closed and covered to prevent spills which could stain it and cause unpleasant odors. To clean both the interior and exterior, use a sponge with warm water and baking soda, which is, among other things, a good disinfectant. - All the removable part should be taken out and allowed to soak in hot water and dishwashing soap. If you decide not to use the appliance (during the summer), it must cleaned and the doors left open to prevent the formation of mold and unpleasant odors. [. . . ]