User manual BARTSCHER 301401

[. . . ] Do not try to repair the problem by trying to access the internal components of the appliance. If damaged, the power supply cord on this appliance must necessarily be replaced by our service centre because special tools are required for replacement. Do not use electric appliances inside the compartment for food storage, if these are not those recommended by the manufacturer. At the end of the functional life of your appliance – containing cyclopentane gas in the insulation foam and perhaps gas R600a (isobutane) in the refrigeration circuit – the latter should made safe before being sent to the dump. [. . . ] The thermostat automatically regulates the temperature inside the appliance 1 = less cold 5 = colder It is recommended that a medium setting be used. To increase the amount of space, optimize arrangement and improve appearance, this appliance has a “cooling area” located within the back panel of the refrigerator compartment. When the appliance is operating, this panel may be covered with frost or droplets of water depending on whether the compressor is operating or not at a given time. If the thermostat knob is positioned on higher settings while the refrigerator is heavily filled and the ambient temperature high, the appliance may run continuously, resulting in the formation of frost on the back cooling area. To avoid this situation, just turn the thermostat knob to a lower setting so that the appliance defrosts automatically. System (Ariston Integrated Refrigeration) which allows an optimal food storage while simplifying the use of the refrigerator thanks to the following features: - Fast temperature reset: after the doors heve been opened, the internal temperatures return to optimal values faster, improving food storage. - More uniform temperature distribution: this makes it possible to place any type of food on any shelf. Remember to follow our instructions on the storage life of foods: If not stored properly, even the freshest food will deteriorate quite quickly. Contrary to popular belief, cooked foods do not keep longer than fresh food. The refrigerator compartment is equipped with practical slide-out shelves (Fig. Do not store liquids in unsealed containers since this will increase the humidity and lead to the formation of frost in the refrigerator. WARNING: every time you fill up the ice tray with water , make sure that the same is completely empty and that there are no traces of ice left inside it. The minimum time required for ice to form well is approximately 8 hours. WATER LEVEL MAX WATER LEVEL MAX Ice trays This new concept of ice trays is an exclusive Merloni patent. The fact that they are situated on the inner door of the freezer compartment ensures greater ergonomics and cleanliness: the ice no longer comes into contact with the food placed inside the freezer compartment; furthermore, the dripping of the water during filling is avoided (a lid to cover up the hole after filling with water is also provided). To remove the ice trays from their housings, push the tray upwards and then pull it out (fig. To put the tray back in place, insert the top part into the special housing and, once in a vertical position, just let it drop into place. 5 13 GB Tips on Saving Energy - Install the Appliance Correctly This means that the appliance should be installed away from heat sources or direct sunlight in a well ventilated room. tHE ACTUAL ENERGY CONSUMPTION OF THE APPLIANCE DEPENDS ON THE WAY THE SAME IS USED AND ON ITS LOCATION. The consumption tests were performed in 560mm deep column units, the most common installation setting for this appliance. - Use the Right Temperature Setting A setting which is too cold increases energy consumption. - Do not Overfill To conserve food properly, the cold air must circulate freely within the refrigerator. [. . . ] Then wrap all the frozen and fast-frozen food in newspaper, placing it either in the refrigerator or in a cool place. You can speed this process by placing containers of warm water in the compartment. Have you checked whether: • The main switch for the electricity to the apartment or home has been turned off; • The plug is properly inserted in the outlet; • The outlet is adequate; try inserting the plug into another outlet in the room. If after all the checks, the appliance still does not operate or the problem persists, call the nearest Service Centre and inform them of: the type of problem, the abbreviation of the model name (Mod. [. . . ]