User manual BARTSCHER 286602

[. . . ] If it is placed on a fitted or loose carpet, adjust the feet in such a way as to allow enough room for ventilation beneath the washing machine. Remove the 2 protective screws and the rubber washer with the respective spacer, situated on the rear of the appliance (see figure). Insert seal A into the end of the inlet hose and screw the latter onto a cold water tap with a 3/4 gas threaded mouth (see figure). Before making the connection, allow the water to run freely until it is perfectly clear. [. . . ] Take out your laundry and leave the appliance door ajar to allow the drum to dry thoroughly. If you wish to start a new wash cycle, the door must be opened and shut for safety reasons before the START/CANCEL button is pressed again. ) 8 9 40°C 30°C • • • • 2, 5- 3 3-4 60 80 Large loads Bed & Bath Feather duvets 10 11 12 13 60°C 30°C 30°C 40°C • • • • • • • • 6, 5 4 4 4 90 75 65 70 Synthetic quilts Woollen blankets Wash cycle, rinse cycles, intermediate and final spin cycles Wash cycle, rinse cycles, an ti-crease intermediate and final spin cycles Wash cycle, rinse cycles, an ti-crease intermediate and final spin cycles Wash cycle, rinse cycles, intermediate and final spin cycles Rinse cycles and spin cycle Draining and spin cycle Draining PAR TIAL PROGRAMMES Rinse Spin Drain • Notes - To ensure the machine operates correctly and is able to achieve the best possible washing performance, we recommend that the maximum load indicated is not exceeded. Special programme Daily 30' (programme 7 for Synthetics) is designed to wash lightly soiled garments in a short amount of time: it only lasts 30 minutes and allows you to save on both time and energy. By setting this programme (7 at 30°C), you can wash different fabrics together (except for woollen and silk items), with a maximum load of 4 kg. 18 Personalisations If, when the appliance is switched on, the KNOB is positioned appears. Press on a programme with a spin cycle, a fixed button and the maximum spin speed allowed for the programme set will be displayed, and the icon flashes. Press it again and the values lower until they reach OFF, which indicates that the spin cycle has been excluded (press it again to go back to the maximum value); stop on the desired speed, after approximately 2 seconds the setting is accepted: the remains fixed. The spin cycle setting is enabled with symbol all the programmes except for 9 and the Draining cycle. Setting the spin cycle GB Installation Option buttons Description If, when the appliance is switched on, the KNOB is positioned on a programme for which the temperature appears. Press button and the maximum temperature allowed for the needs to be regulated, a fixed programme set will be displayed and the icon flashes. 20 Precautions and advice  The washing machine was designed and built in compliance with the applicable international safety regulations. The following information is provided for your safety and should consequently be read carefully. The crossed out "wheeled bin" symbol on the product reminds you of your obligation, that when you dispose of the appliance it must be separately collected. Consumers should contact their local authority or retailer for information concerning the correct disposal of their old appliance. GB Installation General safety • This appliance has been designed for nonprofessional, household use and its functions must not be changed. • This washing machine should only be used by adults and in accordance with the instructions provided in this manual. • Never touch the washing machine when barefoot or with wet or damp hands or feet. • Do not pull on the power supply cable to unplug the appliance from the electricity socket. • Do not touch the drain water as it could reach very high temperatures. • Never force the washing machine door: this could damage the safety lock mechanism designed to prevent any accidental openings. • In the event of a malfunction, do not under any circumstances touch internal parts in order to attempt repairs. [. . . ] • The European Directive 2002/96/EC on Waste Electrical and Electronic Equipment, requires that old household electrical appliances must not be disposed of in the normal unsorted municipal waste stream. Old appliances must be collected separately in order to optimise the recovery and recycling of the materials they contain and reduce Troubleshooting Service Care and maintenance GB Cutting off the water or electricity supply • Turn off the water tap after every wash. This will limit the wear of your appliance's water system and also prevent leaks. • Unplug your appliance when cleaning it and during all maintenance operations. [. . . ]