User manual BARTSCHER 2856201

[. . . ] 8 Before plugging the appliance into the mains, check that the specifications indicated on the date plate (on the appliance and/or packaging) correspond with those of the electrical and gas systems in your home. 9 Check that the electrical capacity of the system and sockets will support the maximum power of the appliance, as indicated on the data plate. 10 An omnipolar switch with a contact opening of at least 3 mm or more is required for installation. 11 If the socket and appliance plug are not compatible, have the socket replaced with a suitable model by a qualified technician, who should also check that the cross-section of the socket cable is sufficient for the power absorbed by the appliance. [. . . ] 11 Installation The following instructions should be read by a qualified technician to ensure that the appliance is installed, regulated and technically serviced correctly in compliance with current regulations. Important: disconnect the cooker from the electricity when making any adjustement, maintenance operation, etc. Positioning The appliance can be installed next to furniture units which are no taller than the top of the cooker hob. For proper installation of the cooker, the following precautions must be taken: a) Kitchen cabinets installed next to the cooker that are taller than the top of the hob must be situated at least 200 mm from the edge of the hob. B) Hoods must be installed according to the requirements in the installation manual for the hoods themselves and in any case at a minimum distance of 650 mm. C) Place the wall cabinets adjacent to the hood at a minimum height of 420 mm from the hob (see figure). D) Should the cooker be installed beneath a wall cabinet, the latter should be situated at least 700 mm (millimetres) away from the hob, as shown in the figure. E) the cut-out for the cooker cabinet should have the dimensions indicated in the figure. Pull and open the junction block lid For the installation of the feeding cable carry out the following operations: · Position the small connection A-B according to the type of connection that has to be performed using the scheme shown in the figure D. Note: the small connections are prepared by the Factory for the 230V monophase connection (contacts 1-2-3 are connected to one another). Introduce the cables (N and 6) as shown in the figure and tighten the relative screws. This grill is larger than the average and has a completely new design: cooking performance is increased 50%. The double grill makes sure that even the corners are touched by heat. Important: when using the grill, keep the oven door closed to obtain the best results and save energy (about 10%). When utilizing the grill, place the rack at the lower levels (see cooking table). To catch grease or fat and prevent smoke, place a dripping-pan at the bottom rack level. The rotisserie To operate the rotisserie, proceed as follows: a) place the dripping-pan on the 1st rack; b) insert the special rotisserie support on the 4th rack and position the spit by inserting it through the special hole into the rotisserie at the back of the oven; c) to start the spit, set the oven selection knob (G) on for small quantities of food, or on setting delivers total grill power). The grill 8 permits turning on the oven light without any heating element being switched on. When the oven light is on, it means that the oven is in use, and it will remain on for the entire time the oven is being used. Static oven - Knob “G” setting: a - Knob “N” setting: anywhere between 50°C and Max The oven light turns on and the top and bottom heating elements (resistors) switch on. The temperature, fixed by the thermostat knob, is reached automatically and kept constant by the thermostat control. This function permits cooking and type of food thanks to excellent temperature distribution. [. . . ] This will allow you both to obtain excellent results and to save on energy (approximately 10%). Table 1 includes the recommended temperatures, cooking times and positions for you to obtain the best results when cooking. 16 Cooker routine maintenance and cleaning Before each operation, disconnect the cooker from the electricity. To assure the long life of the cooker, it must be thoroughly cleaned frequently, keeping in mind that: · Do not use steam equipment to clean the appliance. [. . . ]