User manual BARTSCHER 110425

[. . . ] The manufacturer does not accept liability for any damage or malfunction resulting from not following the instructions for use. The instruction manual should be kept near the device, easily accessible for anyone wishing to work with or using it. We reserve the right to make technical changes for purposes of developing and improving the useful properties. The instruction manual including any texts, drawings, images or other illustrations is copyright. [. . . ] Safe operation is only guaranteed when using the device for its intended purpose. Any technical interventions, as well as assembly and maintenance are to be made by a qualified customer service only. The convection oven is intended only for the following methods of preparing food products: cooking of meat, fish and vegetables; baking bread, cakes and pies; heating food products; thawing of deep-frozen food products; baking; processing of cooled and frozen dishes. The convection oven can not be used for: heating interior spaces; drying clothes; storage of flammable materials; heating of flammable substances, substances dangerous to health, volatile substances, nor similar fluids or materials. Any use going beyond the intended purpose and/or any different use of the device is forbidden and is not considered as conventional. Any claims against the manufacturer or his authorized representative as a consequence of experiencing damages resulting from unconventional use are impossible. Please check the delivery upon completeness and transport damage immediately after receipt. In case of visible damage do not accept or accept the delivery with reservation only. Hidden damages should be reclaimed immediately after notice, as claims for damages can only be asserted within the effective period for complaints. Please do not throw away the covering carton of your device as it might be useful for storage purposes, when moving or, in case of damages, when the device must be sent back to a repair center. The outer and inner packing material should be removed completely from the device before installation. So not place the device directly at walls or other objects that are made of combustible materials. Keep a minimum distance of 100 mm between walls or other objects and the right side, back and top of the device. Keep a minimum distance of 500 mm to the left side of the device and other objects. The levelling and height adjustment using the adjustable legs should be performed as shown in Figure 2. Before connecting the device to power supply, make sure that the voltage and frequency values on the rating plate comply with the values of the available power supply system. Make sure, that there is an earth conductor that complies with the applicable regulations. See that you use a cable with an appropriate cross-section when connecting the device to power supply. The electrical connection requires the interconnection of an all-pole main switch (corresponding to the load) between the device and the power supply system. This switch has contacts with a minimum opening distance of 3 mm and must be placed easily accessible. observe the VDE (VDE Association for Electrical , Electronic & Information technologies) regulations of the local energy supplier. In certain cases the device should be connected to an equipotential bonding system, here the applicable regulations are to be observed. [. . . ] O Use special detergents for ovens only and do not use any kind of detergents for grills or trays that are chemically too aggressive and have a high content of caustic soda as the use of inappropriate detergents may lead to corrosion of the oven accessories. O Only use a soft cloth and make sure you never use any kind of abrasive agents or pads which could scratch the surface. O After the cleaning procedure, you should use a soft and dry cloth to wipe dry and polish the surface. O Make sure the device has been cleaned properly before storing it in a dry place. [. . . ]