User manual BARTSCHER 106793 CONTROL PLAN

[. . . ] The setting is engaged and the second line of the display stops blinking. Envelopes: If you are setting the MP Tray for envelopes, press ON LINE and you are done. Heavy paper / labels: If you are setting the MP Tray for heavy paper or labels, keep going. Press + repeatedly until your choice of CARD STOCK or LABELS appears on the second line of the display. [. . . ] Press + repeatedly until your choice of CARD STOCK or LABELS appears on the second line of the display. The setting is engaged and the second line of the display stops blinking. Press Press + repeatedly until the second line of the display shows the Value (for envelopes, select COM-10 ENVELOPE) you wish to use. The ink on pre-printed letterhead stationery must be able to withstand 446°F (230°C) for 0. If you experience curling when printing a file in duplex mode, switch to 28-lb. Weights in this column are US Bond (see page 10 for more information). Individual Jobs Make the following settings in the printer driver as you print the job: · Individual Jobs Make the following settings in the printer driver as you print the job: · Make the following settings in the printer driver as you print the job: · Size = see sizes at left · Envelopes must be able to withstand 446°F (230°C) for 0. Never use envelopes with metal clasps, snaps, windows, or V-flap seals: Make the following settings in the printer driver as you print the job: · The second line of the display starts blinking. The new setting is engaged and the second line of the display stops blinking. Power Save sets how long the printer waits before going into standby mode. What to Do Replace the toner with a genuine BARTSCHER Toner Cartridge (see page 2). Appears on the second line of the display to indicate that color XXX toner cartridge is getting low. Note If you have changed the LOW TONER item in the SYSTEM CONFIG MENU to STOP, the ATTENTION light will blink and you must either replace the toner cartridge immediately or press the ON LINE button to continue printing. What to Do Be sure you have a genuine BARTSCHER replacement toner cartridge (see page 2) on hand. What to Do Replace the toner with a genuine BARTSCHER Toner Cartridge (see page 2). What to Do Remove the toner cartridge and replace it with a genuine BARTSCHER Toner Cartridge (see page 2). Appears on the second line of the display to indicate that the media in tray t is almost out. What to Do Load more media in the tray before printing any large print jobs from that tray. Install additional memory in the printer (see your on-line User's Guide for more information). Note If the message still appears, push the blue latches at either end of the fuser back (toward the printer cover hinge) and lift the fuser out, then lower it back into the printer, pushing it firmly down in place. [. . . ] Install additional memory in the printer (see your on-line User's Guide for more information). Note If the message still appears, push the blue latches at either end of the fuser back (toward the printer cover hinge) and lift the fuser out, then lower it back into the printer, pushing it firmly down in place. The printer has received a job for printing from the Multi-Purpose Tray and no media is loaded in the tray. What to Do Load the requested media (xxx) in the Multi-Purpose Tray, then press ON LINE. [. . . ]