User manual BARTSCHER 103.065

[. . . ] All the information and instructions in this manual take into account standard safety regulations, current levels of technical engineering as well as the expertise and experience we have developed over the years. The instruction manual was translated with all due care and attention. If the delivery consists of a special model, the actual scope of delivery may differ from the descriptions and illustrations in this manual. This is also the case for special orders or when the device has been modified in line with new technology. [. . . ] The outer and inner packing material should be removed completely from the device before installation. If you liked to dispose the packing, consider the regulations applicable in your country. In case any part is missing please contact our customer service center immediately. Keep the package closed until installation and under consideration of the outside indicated positioning- and storage markings. Packages should be stored under consideration of the following: Do not store outdoors. In case of longer storage (> 3 months) make sure you check the state of the packaging and the parts regularly. ON/OFF switch with control light Stainless steel casing; two chambers for plates with a platform for stacking; each chamber has 4 adjustable leads to set the platforms at desired heights; the chamber suspension system is adjustable and can support various weights; plates are always ready for use; when one is removed, it is replaced at the top by the next one; each chamber can hold around 50 plates, depending on the thickness of each plate; the rolling plate dispenser is equipped with a heating system and ventilator, which ensures quick and even heating of the plates; the safety shield under the platform prevents direct contact between the plates and heating element. The device must only be connected to a properly installed single socket with protective contact. Do not use the device in case it does not function properly, has been damaged or dropped. Do not use any accessory or spare parts that have not been recommended by the manufacturer. These can be dangerous for the user or lead to damages of the device or personal injury, and further, the warranty expires. Keep away the cable from operating range and do not dunk it into water. Before installation the local power grid specification should be compared with that of the device (see type label). Place the device on a flat, secure surface that can support the device's weight and is resistant to high temperatures. Never leave the device near an open flame, electric furnace, coal furnace or any other sources of heat. The device can be used in ambient temperatures up to 32° at normal humidity. C Do not leave the device in the vicinity of any steam-producing equipment. Failure to secure the device can cause it to move unexpectedly and may result in injuries or damage to the device. Do not place metallic objects or other things on the device that may leave traces of rust. Only connect the device directly to a grounded socket; do not use an extension cord or multiple plug socket. Place the device so that the plug is easily accessible and if necessary can be quickly disconnected from its power source. While heating, the device may emit an unpleasant odour resulting from the heating of insulation material. [. . . ] The above described problem cases are given for orientation and as examples. Should these or similar problems occur, please turn off the machine immediately and don´t use it anymore. In order to check and repair your machine, please contact a qualified expert or the manufacturer immediately. At the end of its service life the discarded device has to be disposed in accordance with the national regulations. [. . . ]