User manual BARTSCHER 101954

[. . . ] The electrical connection must be in accordance with the stated requirements on the data plate fixed to the rear panel of the appliance. When the appliance is in operation ensure that the voltage does not vary from the fixed value by more then +/-10%. According to the rules in force the equipment installation must be done by an Omni polar switch between power grid and equipment with a contacts opening of at least 3 mm. [. . . ] According to the rules in force the equipment installation must be done by an Omni polar switch between power grid and equipment with a contacts opening of at least 3 mm. Make sure that the appliance is in a perfectly level position by regulating the feet, if necessary. Use an appropriate lagging by setting the appliance near inflammable walls and furniture; fire prevention prescriptions must be followed very strictly. Leave a free space of at least 15 cm from inflammable side walls and back. The equipment installation must be done in the respect of local prescriptions and according to the European rules in force. It is important to follow the setting up procedure exactly : Press switch A to light the cooking chamber. press the gear-motors switches (B) to start them for the spits rotation. unplug the appliance by removing the set upwards Omni polar switch or by unplugging. Never use abrasive or corrosive substances, they could damage the surfaces. Instrument board, handles, glasses and switches have to be cleaned with a wet soft cloth. It is advisable, especially in case of continual use, to clean the glasses periodically with a cloth dipped in lukewarm water. A cloth dipped in cold water could cause a thermal shock and break the glasses. Should any anomalies in the working be noted, switch off the machine, disconnect it and call the assistance service. FEEDING CABLE REPLACEMENT In case of the damage of the feeding cable it must be replaced with a properly one having the following features : it must not be lighter than the type H07 RN-F it must have a conductors section of at least : During the connection pay attention that the round wire must be longer than the other ones; in fact, in case of strong wire traction or rupture of cable connection it must be disconnected after the live conductors. [. . . ] Should any anomalies in the working be noted, switch off the machine, disconnect it and call the assistance service. FEEDING CABLE REPLACEMENT In case of the damage of the feeding cable it must be replaced with a properly one having the following features : it must not be lighter than the type H07 RN-F it must have a conductors section of at least : During the connection pay attention that the round wire must be longer than the other ones; in fact, in case of strong wire traction or rupture of cable connection it must be disconnected after the live conductors. Unscrew the bulb and replace the light with a new one having the same features; plug the protection back on. [. . . ]