User manual BARTSCHER 100322

[. . . ] In this manual, symbols are used to highlight important safety instructions and any advice relating to the device. The instructions should be followed very carefully to avoid any risk of accident, personal injury or material damage. Please follow the instructions very carefully and proceed with particular attention in these cases. If you do not follow the safety instructions, you may risk injury or death. [. . . ] Please do not throw away the covering carton of your device as it might be useful for storage purposes, when moving or, in case of damages, when the device must be sent back to a repair center. The outer and inner packing material should be removed completely from the device before installation. If you liked to dispose the packing, consider the regulations applicable in your country. In case any part is missing please contact our customer service center immediately. Keep the package closed until installation and under consideration of the outside indicated positioning- and storage markings. Packages should be stored under consideration of the following: Do not store outdoors. In case of longer storage (> 3 months) make sure you check the state of the packaging and the parts regularly. The device must only be connected to a properly installed single socket with protective contact. Do not use the device in case it does not function properly, has been damaged or dropped. Do not use any accessory or spare parts that have not been recommended by the manufacturer. These can be dangerous for the user or lead to damages of the device or personal injury, and further, the warranty expires. After 3 seconds the display will show in red the internal unit temperature during rapid cooling (-5° This value may be changed using the buttons marked ). Confirm the value with the , , cooling with temperature regulation via probe for measuring internal product temperature" button 3. During the conservation phase, the internal unit temperature will be displayed in red. During the rapid cooling cycle it is possible to view the internal unit temperature by pressing the button , , cooling with temperature regulation via probe for measuring internal product temperature display for 5 seconds. The internal unit temperature will appear in green on the If you wish to remove the food product from the refrigerator-flash freezer, press the START button to suspend the rapid cooling cycle. To place the unit in STANDBY mode, press and hold for 3 seconds one of the following The refrigerator-flash freezer is prepared for a new rapid cooling cycle. To begin the next cooling cycle, press and hold for 3 seconds one of the following Insert the probe into the food product. Insert the internal product temperature probe into the food product to a maximum depth of 2 ­ 3 cm. The display will show the current internal again and hold until the display shows the word After 3 seconds the display will show in red the internal unit temperature during rapid cooling (-15° This value may be changed using the buttons marked ). During the conservation phase, the internal unit temperature will be displayed in red. During the rapid cooling cycle it is possible to view the internal unit temperature by pressing the button , , cooling with temperature regulation via probe for measuring internal product temperature" display for 5 seconds. [. . . ] Insert the internal product temperature probe into the food product to a maximum depth of 2 ­ 3 cm. During the conservation phase, the internal unit temperature will be displayed in red. During the rapid freezing cycle it is possible to view the internal unit temperature by pressing the button , , freezing with temperature regulation via the probe for measuring internal product temperature" the display for 5 seconds. The internal unit temperature will appear in green on If you wish to remove the food product from the refrigerator-flash freezer, press the START button to suspend the rapid freezing cycle. [. . . ]