User manual BARTSCHER 100061

[. . . ] Can not be responsible for the serving of potentially hazardous product. Stainless steel is one of the best materials for food serving and storage, but there are many products which can corrode it. If you notice corrosion beginning on any stainless steel surface, you may need to change the cleansing agent, sanitizing agent, or the cleaning procedures you are using. [. . . ] Place lower end of pump into water container and operate pump until all (if any) remaining product is expelled and only the warm water flows from the discharge tube. Then remove pump from container of water to disassemble and use container to collect the small parts of the pump to prevent any loss. Remove plunger assembly and lid from pump body by turning locking collar counterclockwise. Push cylinder into connector to compress ball valve while rotating cylinder counterclockwise. Remove discharge tube body from piston by rotating discharge tube body counterclockwise. Be prepared for ball valve to fall loose when removing discharge tube body from piston. Remove locking collar and gaging collar(s), if used, from piston by sliding them off. Remove seal from end of piston by rotating and pulling off of lip on piston. Install one of the ball valves with ball side seated down into opening in top of piston. Install bottom of discharge tube body onto threaded top of piston with ball valve in position resting on top of piston. Rotate discharge tube body clockwise until secure with pump tube assembly. Install the other ball valve with the ball side seated down into opening inside connector. Install bottom end of pump body, with pins, into connector with ball valve in position resting inside connector. Compress ball valve slightly and rotate pump body into connector until pins secure into slots in connector. Install lid onto pump body by aligning large hole in lid to rest on threaded lip of pump body assembly. Compress pump and rotate until flats on piston align into position with flats inside cylinder. [. . . ] While compressing pump, rotate locking collar clockwise to secure onto threading of cylinder. After cleaning pump and during pump assembly, determine the amount of product you would like to be dispensed with each full stroke of the pump. Gaging collars are included with the pump to allow you to change the portion control. [. . . ]