User manual BARTSCHER 1 BECKEN 16L SCHEMA

[. . . ] · Warnings and Important Safety Instructions in this manual do not cover all possible conditions and situations that may occur. It is your responsibility to use common sense, caution, and care when installing, maintaining, and operating your appliance. · Because these following operating instructions cover various models, the characteristics of your refrigerator may differ slightly from those described in this manual and not all warning signs may be applicable. If you have any questions or concerns, contact your nearest service center or find help and information online at www. [. . . ] Be careful that the door does not fall on you as you are removing it. Be sure to keep track of all parts you are removing. CAUTION Be sure to keep track of all parts you are removing. 3. Next, remove the door from the lower hinge 3 by carefully lifting the door straight up 4 . 4 3. Remove the door from the lower hinge 2 by lifting 3 the door straight up 3 . 2 3 Reattaching the Fridge door CAUTION CAUTION Be careful not to pinch the water tubing and wire harness on the door. To reattach the fridge doors, replace parts in reverse order. Reattaching the freezer doors To reattach the freezer doors, replace parts in reverse order LEVELLING THE REFRIGERATOR Now that the doors are back on the refrigerator, you want to make sure the refrigerator is level so that you can make final adjustments. If the refrigerator is not level, it will not be possible to get the doors perfectly even. setting up _09 When the Freezer part is lower than the Fridge part. Insert a flat-blade screwdriver into a slot on the Freezer Leg, then turn it clockwise. than the fridge Insert a flat-blade screwdriver into a slot on the fridge leg, then turn it clockwise. Screwdriver(-) Freezer Leg When the Fridge part is lower than the Freezer part. Insert a flat-blade screwdriver into a slot on the Fridge Leg, then turn it clockwise. CHECKING THE WATER DISPENSER LINE A water dispenser is one of the helpful features on your new Samsung Refrigerator. To help promote better health, the Samsung water filter removes unwanted particles from your water. In order for the ice maker to operate properly, a water pressure of 20~125 psi (pound per square inch) is required. Under normal conditions, a 170 cc (5. 75 oz. ) paper cup can be filled in 10 seconds. If the Refrigerator is installed in an area with low water pressure (below 20psi), you can install a booster pump to compensate for the low pressure. Make sure the water storage tank inside the Refrigerator is properly filled. To do this, press the water dispenser lever until the water runs from the water outlet. Water line installation kits are available at extra cost from your dealer. To prevent injury, be sure to clean up any ice or water that may have dropped on the floor. It may cause personal injury or damage mechanical parts. Check the amount of water supplied to the ice tray. 1. When you press the Test button for 3 seconds, the ice cube container is filled with water from the water supply tap. Check to make sure the amount of water is correct (see the illustration below). This is a water pressure problem from within the main water pipes, not the refrigerator. 1 - - CAUTION - 2 Ice maker Test button Check the water level CAUTION - - Removing residual matter inside the water supply line after installing filter. 1. (Flush approximately 6 minutes. ) This will clean the water supply system and remove air from the lines. 12_ setting up - It will take a few minutes for the water to reach the correct level after you push the Test button. Do not press the test button continuously when the tray is filled with ice or water. When Ice Off blinks on the display panel, reinsert the bucket and/or make sure it's installed properly. operating the BARTSCHER sideby-side refrigerator USING THE CONTROL PANEL 1 2 3 10 7 9 8 4 5 6 (4) Lighting/ Hold 3 sec for CF Touching the Lighting button turns on the Dispenser LED lamp (under the display) in continuous mode so that it stays on continuously. If you want the Dispenser lamp to come on only when some one uses the dispenser, press the Lighting button to turn the continuous mode off. Touch and hold this button for 3 seconds to switch the temperature units between °C and °F 02 OPERATING (1) Energy Saver Touching this button turns Energy Saver mode on and off. [. . . ] If you have questions about your water pressure, call a licensed, qualified plumber. 3. Turn the new water filter 90° clockwise. Ordering replacement filters To order more water filter cartridges, contact your authorized Samsung dealer. 5. Press the "Alarm/hold 3 sec for Filter Reset" button ( ) for about 3 seconds to reset the 18_ operating troubleshooting PROBLEM The refrigerator does not work at all or it does not chill sufficiently. SOLUTION · · · · Check that the power plug is properly connected. [. . . ]