User manual BARKER & WILLIAMSON AS-160 TRAP ANTENNA

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual BARKER & WILLIAMSON AS-160 TRAP ANTENNA. We hope that this BARKER & WILLIAMSON AS-160 TRAP ANTENNA user guide will be useful to you.


BARKER & WILLIAMSON AS-160 TRAP ANTENNA : Download the complete user guide (76 Ko)

Manual abstract: user guide BARKER & WILLIAMSON AS-160 TRAP ANTENNA

Detailed instructions for use are in the User's Guide.

[. . . ] BARKER & WILLIAMSON 603 CIDCO ROAD COCOA, FL 32926 321-639-1510 MODEL AS-160 ANTENNA 160, 80, 40, and 20 Meter Bands Power Rating: 1000W PEP, 500W Output Length: 137 Feet The Barker & Willamson Model AS-160 is a short dipole for the 160, 80, 40, and 20 meter amateur bands. Each band has a separate trap (80, 40, and 20 meters) which will give maximum efficiency and still be a short antenna for small lots and limited space. [. . . ] It is imperative to follow the instructions step by step, in the order shown, to achieve satisfactory results with your antenna. (2) Remember that throughout the assembly procedure, wire lengths are always to be symmetrical on both sides of the antenna. The wires must be cut approximately 2 - 3 feet longer than the dimensions shown in figure 1. Here are the lengths that you should cut (including the 2 - 3 ft extra). Cut two wires 21', two wires 11' 6", two wires 15', and two wires 33'. Remember, you can always trim the wire shorter after tuning, but once cut too short . (4) Attach one end of the wire segments in the permanent manner shown in figure 2, working out from the center conductor. Allow roughly 6 to 8" of wire through the eyebolt before starting your wrap. (5) Now assemble the sections of the antenna together paying attention to figures 1 and 3. The wire segment lengths shown are your starting point for tuning the antenna. This will leave each wire segment with one end permanently soldered, and the other end temporarily connected for adjustment. After the desired frequency is achieved, make permanent attachment for these segments as shown in figure 2, trimming off excess wire. (7) Next adjust the 8' 7" segments for 40 meters in the same manner. (8) Next adjust the 12' segments for 80 meters in the same manner. [. . . ] We reserve the right to make changes in design at any time without obligation to update previously manufactured models. This warranty is given in lieu of any other warranty, expressed or implied. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE BARKER & WILLIAMSON AS-160 TRAP ANTENNA




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual BARKER & WILLIAMSON AS-160 TRAP ANTENNA will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.