User manual BANG & OLUFSEN BEOLAB6002

[. . . ] If an error occurs ­ or the speaker units become overheated ­ the system automatically switches the loudspeakers to standby, and the indicator light turns orange. Indicator To restore the situation: > Disconnect the loudspeakers from the mains. > Allow the system time to reset When you switch off your system, (approximately 3­5 minutes). or mute the sound, the red indicator light appears immediately, > Reconnect the loudspeakers to the mains. [. . . ] Hook the base plate onto the two guiding pins at the bottom of the speaker column (be careful not to drop the base plate!). Insert the three screws and tighten them securely. Cable connections 5 The loudspeakers can be used with Bang & Olufsen audio, video and link systems. For specific information about the sockets on your system, refer to the Guide enclosed with the system. Power Link connections: These connections carry both the right and left sound signals. Therefore, you can: 1 run a Power Link cable from your Bang & Olufsen system directly to each loudspeaker, or. . . 2 run a Power Link cable from your Bang & Olufsen system to the first loudspeaker, and then run another Power Link cable to the next loudspeaker. This will often help to minimise cable clutter. 1 POWER LINK 2 POWER LINK socket POSITION switch SETUP POSITION SETUP switch LEFT RIGHT LINE CORNER WALL FREE Connection to the mains supply POWER LINK POWER LINK LEFT RIGHT 1 For safety reasons you must run the cables to and from the loud speaker through the cable guides. Mains cord: The supplied mains cord and plug are specially designed for the product. If you change the plug or damage the mains cord, you must buy another from your Bang & Olufsen retailer! LEFT RIGHT 2 6 Adapt the loudspeakers to your setup The loudspeakers may be placed almost anywhere in your room. However, the most natural sound is obtained if they are set up as explained on these pages. SETUP switch This switch has three settings: LEFT, RIGHT and LINE. Set the switch to LEFT or RIGHT when connecting the loudspeakers in a Bang & Olufsen system. Set the switch to LINE when connecting the loudspeakers in a non­Bang & Olufsen system. . . . To a Bang & Olufsen system: Use the enclosed Power Link cables to connect the loudspeakers to your system. Set the SETUP switch to LEFT and RIGHT (the left and right sound channel) respectively. The POSITION switch When a loudspeaker is placed in a corner or close to a wall, the bass level is boosted compared to the bass level from a loudspeaker placed in a more free-standing position. To remove this excessive bass boost, set the POSITION switch to ensure that the bass level suits the placement of the loudspeaker. The appropriate switch setting depends on the distance from the loudspeaker to the walls and corners of the room. Use the guidelines mentioned here, when deciding which of the three POSITION switch settings to select ­ on each loudspeaker. . . . To a non-Bang & Olufsen system: Use a special adaptor with an The position zones, shown on the ordinary phono/RCA plug in one next page, are meant as guidelines end, and a DIN-plug in the other. ­ you may, of course, set the switch Depending on your setup, you may to any of the three settings you also need to connect an adaptor prefer. [. . . ] This class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations. NOTE: This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ]