User manual BANG & OLUFSEN BEOLAB 10

[. . . ] ­ Prolonged listening at high volume levels may cause hearing damage!If necessary, remove grease stains or persistent dirt with a lintfree, firmly wrung cloth, dipped in a solution of water Loudspeaker protection containing only a few drops of The loudspeaker is equipped with a mild detergent, such as washing up liquid. Never use a vacuum cleaner to If an error occurs ­ or the speaker clean the exposed speaker units become overheated ­ the Caution: Do not touch the membrane in the acoustic lens. [. . . ] To be used if the loudspeaker is placed so that the front is more than 50 cm (20") from the rear wall. Acoustic Lens Technology ­ manufactured under license from Sausalito Audio Works. 6 Set up the loudspeaker ­ wall bracket The wall bracket must be fastened to the wall so that the loudspeaker is placed in a centred position immediately below the television screen. We recommend that you place the television screen so that the loud speaker will be at least 10 cm (4") above the floor. 59 cm 23" 10 cm 4" About screws, washers and wall anchors Use the correct size and type of screws, washers and wall anchors ­ taking into account the construction and condition of the wall. Use at least four screws ­ two in each side of the wall bracket. Under each screw head use an appropriatly sized washer with a minimum thickness of 1. 6 mm (0. 07"). Each screw and washer must have a minimum load rating of 16 kg (35 lbs). Additional notice about light partition walls: If you intend to hang the loud speaker on a gypsum wall (also known as drywall or wallboard), the wall bracket must be fastened to a vertical stud!Use one roundheaded lag screw (ø 6 mm ­ 0. 23"), which penetrates the gypsum and is screwed a minimum of 25 mm (1") into a vertical stud. Furthermore, use three additional screws of a type intended for gypsum walls. 7 To fasten the wall bracket 1 Fold the cardboard `tool' as shown, and attach it to the wall bracket. 2 Hold the wall bracket against the wall ­ centred below the tele vision screen. 4 Drill the holes in the wall, and insert the appropriate wall anchors. 5 Fasten the wall bracket to the wall using the appropriate size and type of screws and washers. Make sure that the wall bracket is in the correct position ­ level and centred in the correct distance from the screen edge. [. . . ] Technical specifications, features and the use thereof are subject to change without notice! For the US-market only!NOTE: This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ]