User manual BALAY 3VW500BA annexe 1

[. . . ] en Dishwasher summary of instructions Brief and handy: everything your dishwasher needs . . . Before using for the first time, read the operating instructions! Adjusting the water softening system * Hardness mmol/l Ask your water supply Water hardness range company what the value _dH water hardness is and enter . . . [. . . ] The corresponding programmes for your appliance can be found on the fascia. Duration: hs/mins 9000 340 675 ( 8803-1) The programme data has been measured in the laboratory according to European standard EN 50242. * half normal load 2:15 1, 50 Water consumption in litres 15 Energy Consumption: kWh 2:00 1, 45 14 2:20 1, 05 14 1:10 0, 80 13 0:29* 0, 80 10 0:15 0, 05 4 Start programme Here we go . . . Additional options ** Express Wash (VarioSpeed) . . . is obtained by increased energy consumption at a constant cleaning and drying performance. for a few items, saves water, energy and time Flexibility . . . IntensiveZone . . . improves the drying result by increased temperature in the final rinse (Please take care with delicate dishes) Switch off the appliance Everything o. k. check, if required clean Rotate filter cylinder, remove filter system . . . For perfect rinsing results . . . rinse under running water . . . Screw on filter system NOTE MARK! Cleaning waste water pump ­ Pull out the mains plug ­ Remove filters and scoop out water ­ Lever off cover (­­>A) ­ Check area around the fan impeller for foreign objects ­ Click cover shut (­­>B) ­ Insert filters Spray arms . . . Remove blockages/deposits pull lower arm upwards . . . unscrew upper arm . . . clean spray nozzles under running water (if required use toothpicks) . . . insert lower arm . . . A B screw on upper arm tightly Rectifying minor faults yourself . . . Fault Possible causes . . . as it is worth doing it yourself! Remedial action Fault Utensils are not clean Sand or gritty residue on the utensils Possible causes Utensils are situated close together or one above the other Too little detergent Unsuitable programme selected Spray arm nozzles blocked Filters dirty, not seated firmly Spray arms blocked Remedial action Separate the utensils, prevent contact points. Arrange the utensils so that the spray arms can rotate freely. Display " " display is lit Supply fitting jammed or calcified Open supply fitting. Install supply hose without kinks. Display "E:24" and " " is lit Waste water hose is blocked or kinked Cover not attached to waste water pump Install waste water hose without kinks. Milky deposits on the utensils (can be removed) Rinse-aid dosage too high/too low Streaks: reduce dosage. [. . . ] Discoloration is harmless; subsequent rinse cycles will cause it to fade. Rust on the cutlery More information can be found in the operating instructions Terminating the programme . . . While the programme is running, press the START button for approx. 1 minute after the programme ends, 0:00 is indicated Switching off the appliance Loading the dishwasher correctly . . . Dishwasher-proof utensils (not soiled with ash, wax, lubricating grease, ink or adhesive labels; remove large remnants of jam, milk products and food according to the operating instructions and check that the spray arms can rotate freely. [. . . ]