User manual BALAY 3TI60081A

[. . . ] Installation and operating instructions en Washing machine Please read the installation and operating instructions and all the other information supplied and handle the appliance accordingly. Keep all documents in a safe place for future reference, or to pass on to the next owner. For further information and a selection of our products, visit our website: http://www. balay. es Table of contents Operating instructions General safety information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Environmental protection/economy tips . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The water is emptied and the washing machine spins. $ flot (Rinse stop) & i The maximum spin speed depends on the selected washing programme. If you do not wish to spin the laundry: Set the programme selector to (Empty). The programme has finished when the fin/fim (finished) indicator light flashes. Leave the loading door open in order that the inside of the washing machine can dry. t/D Programme change You have selected an incorrect programme by mistake: Select the programme again and press !The new programme starts from the beginning. 13 Adding laundry If you want to add laundry after the programme has started, press and hold the !Note: If the water level and/or temperature is high or if the machine is spinning, the loading door remains locked for safety reasons. inicio/pausa (Start/Pause) button until all three programme progress lights light up. For washing programmes at high temperatures: ­ Cooling the laundry: select O/C (Rinse + Spin). For programmes with a low temperature: ­ Select O/C (Rinse + Spin) or (Empty). inicio/pausa (Start/Pause). Programme termination t/D Reset function ­ You can use the Reset function to return to the original settings. inicio/pausa (Start/Pause) button until all three programme progress lights light up. 14 Cleaning and care Safety information Risk of electric shock. Risk of scalding Hot detergent solution must be allowed to cool before being drained. Housing and control panel Washing drum ­ Remove detergent residues immediately. ­ Cleaning with a jet of water is prohibited. ­ Remove any foreign bodies from the drum and rubber seals. Never use steel wool. Detergent drawer If there are detergent or care product residues: Pull out the detergent drawer as far as the stop. Clean the detergent drawer and fabric softener compartment insert under running water. Not necessary if the correct measures of detergent are used but, if still required, follow the information provided by the descaler manufacturer. Suitable descalers can be ordered via our website or from our after-sales service page 21. Descaling the washing machine 15 Detergent solution pump Notes on blockages Set the programme selector to stop (Off). Fold up the servicing panel and remove it upwards. Draining the water Remove the drain hose from its retainer. Remove the sealing cap from the drain tube and allow the water to drain off. ­ The container for the drained water may have to be emptied several times. Place the drain hose into the retainer. Cleaning the detergent solution pump Carefully unscrew the pump cover (remaining water). ­ Clean the interior, pump cover threads and pump housing (it must be possible to turn the impeller). [. . . ] Only use the inlet hose supplied or one which was purchased from an authorised specialist retailer. ­ The water inlet and outlet hoses can be routed to the left of right, depending on installation conditions. 24 Water inlet Do not allow the water inlet hose to be: ­ Kinked or squashed, modified and cut (strength no longer guaranteed). Note the water pressure in the mains supply: ­ The water pressure should be between 50-900 kPa (0. 5-9 bar) (at least 8 litres of water per minute flow when the tap is open). ­ If the water pressure is higher, a pressure reducing valve must be installed. [. . . ]