User manual BALAY 3SB988BA

[. . . ] Please take a few minutes to read and become familiar with the advantages of your tumble dryer. To meet the high quality demands required by Balay, every tumble dryer that leaves our factory is carefully checked to ensure that it functions correctly and is in perfect condition. For more information on our products, accessories, replacement parts and services, see our website www. If the operating and installation instructions describe different models, any differences will be pointed out at the relevant points in the text. [. . . ] Condensation Draingthecondsatiwater will form in the appliance as it dries the laundry. You must ensure that the drain hose is connected when you operate the appliance. If there is no drain hose connected to the appliance, the condensation water from the appliance will run into the condensation container. In this case, you will need to empty the condensation container each time the dryer finishes drying the laundry, and also if it becomes full before drying is complete. Remove the accessories from the Disconnect the hose from the connecting piece and put it in the "parked" position. Take the drain hose from the accessories and secure it to the free connecting piece. When the dryer is delivered from the factory, the hose for discharging the condensation into the condensation container is fastened to the connecting piece. Fasten the other end of the drain hose with the remaining accessories, depending on the connection situation (A, B or C). Accumulated water can be drawn back into the dryer and may cause material damage. 80 cm between the installation surface and the drain is maintained for drainage into a siphon. Pull the filter out of the lock-in slot and place it into the recess in the top of the condensation container. Turn the condensation container 180° onto its underside and remove the stopper that is fitted. Turn the condensation container back over and insert the stopper into the recess in the top of the condensation container. The condensation is now discharged via the drain hose into the waste-water system or into a wash basin Note: If you want to drain the condensation water back into the condensation container, reverse these steps. Select a programme and, if necessary, adjust the programme default settings. ( Condensate container 0 Control and display panel 8 Drum interior light (depending on the model) @ Dryer door H Air inlet P Fluff filter Getting to know your appliance en ( Use the programme selector to switch the dryer on and off and to select 8 Start button for starting or interrupting the programme ~ Page 26. When "Ready in" time is Remove any cigarette lighters and matches from pockets. Remove all objects from pockets and observe the following information: Tie cloth belts, apron strings, etc. to ensure a consistent drying result , sort laundry by fabric type and drying programme. Knitted fabrics such as T-shirts and jerseys often shrink the first time they are tumble-dried. Starch or softeners, contain particles which may be deposited on the moisture sensor. This may impair the sensor function and in consequence the drying result. [. . . ] Laundry is not dried cor- After the programme has ended, warm laundry feels damper than it acturectly or is still too damp. Finely adjust the dryness level ­ this extends the drying time but does not increase the temperature. Select a programme with a longer drying time or increase the dryness level. Select a timed programme to add extra drying time for laundry that is still damp ~ Page 24. [. . . ]