User manual BALAY 3HB559AP

[. . . ] 5 5 6 8 10 10 10 11 11 12 13 13 15 15 16 16 17 18 18 20 22 24 24 25 27 29 30 30 30 31 3 Table of contents Changing the basic settings . 32 33 34 35 35 36 37 37 38 38 40 41 43 44 46 46 48 48 49 50 50 50 51 51 52 52 56 59 60 4 Safety information Read the instructions in this manual carefully. This instruction manual is for use with both stand-alone ovens and oven-hob combinations. Read the instruction manual supplied with the hobs of oven-hob combinations to find out how their hob controls work. Before installation Transport damage Check the appliance after removing it from its packaging. [. . . ] Activating the childproof lock Press and hold the @ switch until the @ symbol appears. Locking the oven door You can change the basic settings so that the oven door also locks. If the child lock is activated the oven door will lock when the temperature inside the oven reaches 50 ºC and when the oven is switched off. Even if the childproof lock is active, you can still switch off the oven with #, set the timer and turn off the acoustic signal. Following a power cut, the childproof lock is no longer active. Releasing the lock Notes 31 Changing the basic settings This oven has different basic settings. Warning The following table shows the basic settings and the possible options. Basic setting b = Spanish Options b = Spanish c = Portuguese d = Greek e = English f = German k = deactivated b = activated Function okb Language okc Time indicator when the oven is switched off Changing the time Switch confirmation beep Duration of acoustic signals b = activated The time appears on the display b = activated c = average okd oke k = deactivated b = activated b = short c = average d = long k = no b = yes k = no b = yes b = short c = average d = long e = very long okf okg Telescopic shelves are retrofitted Lock the oven door with the childproof lock Operating time for refrigeration fan b = yes k = no d = long okh oki 32 Changing the basic settings Please read the basic settings table to find out what each setting is. Example in the picture: Changing the basic setting for the operating time for the refrigeration fan, from long to short. 1. Switch the oven on using the # switch. Then press the O switch for approximately four seconds until the first function okb and the first basic setting b appears on the display. 2. Select the desired setting using the control knob. Follow steps 2 and 3 to change the next settings. 4. Press the O switch for approximately four seconds Exiting the menu without saving the settings until the indicators disappear. The new settings have not been saved. Automatic switch off Your oven has an automatic switch off function. It is activated if no cooking time is set and the settings have not been changed for a long time. The point at which this occurs depends on the temperature or grill setting that has been set. Note If a cooking time has been set, the oven will stop heating once the cooking time has elapsed. The automatic switch off function is not required. 34 Self cleaning During self cleaning, the oven heats up to approx. Residues from roasting, grilling and baking are incinerated and you need only wipe the ash out of the cooking compartment. Level 1 2 3 Degree of cleaning gentle moderate intensive Duration approx. 2 hours The heavier and older the dirt, the higher the cleaning level should be. It is sufficient to clean the cooking compartment every two to three months. 2. 5 4. 7 kilowatt hours. Important notes For safety reasons, the oven door locks automatically. You cannot open the oven door again until the cooking compartment has cooled slightly and the padlock symbol for the locking mechanism disappears. [. . . ] Example in the picture: Pork ribs, program 7, weight 1. 3 kg. 56 1. Press the = switch. The number of the first program appears between brackets on the temperature display. 2. Press the A switch. A weight option is activated within brackets on the time display. 57 4. You can cancel the signal early by pressing the 0 button. Suggestions for changing the settings: Changing the duration of the program Changing the program Cancelling the programme Changing the function end time Once the function has started the duration cannot be changed. [. . . ]