User manual BALANCE KH 415 HAIRDRYER

[. . . ] The hairdryer standing on a wet ground or when your hands or the appliance are wet. Never try to open the appliance or to get inside it for example with metallic objects. If you do not keep to the instructions according to the use of the appliance or if you operate it in the wrong way the responsibility for the resulting damages will not be accepted! [. . . ] Let the appliance cool down for about 10 minutes before using it again. do not use the appliance for wigs or hairpieces of synthetic material. Only use the appliance to dry and do your hair, not for other purposes. Two adapter plugs accompany the hairdryer as accessories which enable your appliance to be used worldwide. Put the respective adapter onto the plug before connecting the appliance. This hairdryer has a 3-step switch: "0" = Off, "1" = low temperature/low airflow, "2" = high temperature/high airflow. For quick hairdrying we recommend the use of the setting "2" first, after a while switch to setting "1" to do your desired hairstyle. With the enclosed styling nozzle turnable into every position you can use the air stream well-directed for styling. Before combing your hair let it cool down first, so that your hairstyle keeps its shape. In addition a "finger"-diffusor accompanies the hairdryer which enables you to dry your hair in a particular mild way, for example when you have permanent waves. The use of the diffusor is also very recommendable with so-called "air-dried" permanent waves because you get nearly the effect of the airdrying. Remove hair and dust from the air inlet grille with a small brush at regular intervals. Please read these instructions carefully before putting the appliance into operation. Before switching on your appliance check at any rate if the right mains voltage is set. [. . . ] The same goes for damages of the power cable or the appliance or if the hairdryer has been dropped. Take care that the power cable and the appliance are situated never on hot surfaces or near heat sources. Position the power cable in a way that contact to hot or sharp-edged objects is impossible. [. . . ]