User manual BABYLISS E764XDE

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual BABYLISS E764XDE. We hope that this BABYLISS E764XDE user guide will be useful to you.


BABYLISS E764XDE : Download the complete user guide (2479 Ko)

Manual abstract: user guide BABYLISS E764XDE

Detailed instructions for use are in the User's Guide.

[. . . ] These two technologies provide perfect surface condition and their combination is optimal for reducing the friction coefficient. Cleaning brush and comb IMpORTANT INFORMATION REGARDING THE NI-MH BATTERIES OF THIS UNIT To obtain and maintain the longest battery autonomy possible, allow it to charge for 16 hours before using it for the first 7 Time and then approximately every three months. [. . . ] 2) To remove the cutting guide, first adjust the cutting length to 3mm or 21mm and push the guide out of the support lifting it up with your thumb. Thanks to the SMART ADJUSTING SYSTEM, the length of the cut is maintained even if the angle of the clipper varies, so it guarantees precise result. To familiarize yourself with the clipper, begin with the cutting guide for a longer cut, then, if you want a shorter cut, adjust it by pushing the knob. Place the guide on the scalp and move the clipper toward the crown of your head. Move your clipper slowly, pointing the teeth of the guide slightly upward. For the crown of the head, move from front to back, that is, from your forehead to the crown of your head. For the finishing touches, that is, around the nape and sideburns, use the clipper without a cutting guide. If you want a length greater than 30 mm, or if you are experienced, you can create `comb' or `finger' cuts: - Work without a cutting guide. - Move the comb or your fingers along the section of hair to the desired length. - Remove the cut hair using a comb and check the evenness of the cut regularly. The technique is particularly good for the crown of the head where hair is usually thicker. To thin you hair, take a section of hair (rest your little and ring fingers on your scalp, using the middle and index fingers to set the length), hold 1 to 2 cm below the cutting length. [. . . ] Slut transformatorn till elnätet och stick stickproppen i apparaten. För att tunna ur håret, ta en slinga (låt lillfinger och ringfinger vila på huvudet, tummen och pekfingret bestämmer längd), och kläm till 1 till 2 cm under klipplängden. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE BABYLISS E764XDE




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual BABYLISS E764XDE will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.