User manual AVM P2

[. . . ] Setting of cartridge type Use the mini-switches (3, 6) on the rear panel to set the P2 to MM or MC depending on the cartridge type. [. . . ] Solder the resulting capacitance into the RCA plugs connected to the P2's load terminals. MC: First find out the recommended resistive load (see manual of cartridge). Then see table below for additional resistance values to be soldered into the RCA plugs connected to the P2's load terminals. Total load 1000 500 300 150 100 resistor none 1000 429 176 111 Total load 75 50 30 20 10 resistor 81 53 31 20 10 Operating instructions Phono pre-preamplifier /equalizer P2 Technical data P2 Sensitivity Input impedance S/N ratio Frequency response Power supply Dimensions Weight MM 1, 5 mV 47 kOhms/47 pF 79 dB /85 dB(A) MC 180µV 1 kOhm / 1 nF 74 dB / 80 dB(A) 30 Hz ­ 20 kHz +/- 0, 3 dB (RIAA courve) 230V / 50 Hz / 3VA (AC adaptor) 145 x 48 x 70 mm 0, 3 Kgs AVM Next Generation GmbH, Daimlerstraße 8, 76316 Malsch Issued: 12/2007. Changes reserved without notice Dear customer, thank You for purchasing this AVM product. After that You will know how to use your new AVM component in the optimal way. Sincerely Yours Your AVM-Team Rear Panel Declaration of conformity (for EC only) We herewith confirm, that the unit to which this manual belongs fulfills the EC rules necessary to obtain the sign 1 power supply connector 2 audio output 3 MM / MC-selector right channel 4 audio input from cartridge 5 load terminals 6 MM / MC-selector left channel 7 ground connector Power supply insert the supply plug of the AC adapter into the power supply connector (1). CAUTION: In case of thunderstorm or if You leave the house for a longer time we recommend that You disconnect the unit from mains. the necessary measurements were taken with positive results. Connection to hi-fi set NOTE: We recommend that You disconnect mains before You make the connections. [. . . ] Do NOT use the phono input because the P2 already amplifies and equalizes the cartridge signal to a high level signal. [. . . ]