User manual AVANTI WD30EC INSTRUCTION MANUAL

[. . . ] ____________________________________ Model Number Write down the model and serial numbers. You'll find them on a label located on the back side of the unit. Please write these numbers here: ____________________________________ Date of Purchase ____________________________________ Serial Number Use these numbers in any correspondence or service calls concerning your water dispenser. If you received a damaged water dispenser, immediately contact the dealer (or builder) that sold you the water dispenser. [. . . ] LY CUPS RECOVERY TIME CAN TAKE UP TO 1 HOUR. NOTE: Your water dispenser has been cleaned and sanitized before leaving the factory, but in case a taste problem develops, place one tablespoon of baking soda and add tap water. Fill water tank again and repeat basic operations previously outlined. OPERATING YOUR WATER DISPENSER Electrical Connection ?WARNING? IMPROPER USE OF THE GROUNDED PLUG CAN RESULT IN THE RISK OF ELECTRICAL SHOCK. IF THE POWER CORD IS DAMAGED, HAVE IT REPLACED BY AN AUTHORIZED AVANTI PRODUCTS SERVICE CENTER. This appliance should be properly grounded for your safety. The power cord of this appliance is equipped with a three-prong plug which mates with standard three prong wall outlets to minimize the possibility of electrical shock. Plug the appliance into an exclusive properly installed-grounded wall outlet. Do not under any circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding should be directed toward a certified electrician or an authorized Avanti Products service center. The cord should be secured behind the appliance and not left exposed or dangling to prevent accidental injury. If the power cord is too short, have a qualified electrician or service technician install an outlet near the appliance. Insert the water bottle on the water intake over reservoir opening so it settles properly on it. When the water reaches the right temperature the green (COLD) indicator goes off automatically. The red (HOT) indicator will be lit on and the unit will begin to heat the water. When the water reaches the right temperature the red (HOT) light goes off automatically. 86º C (187º F), the red indicator will glow again and another 8 heating process starts. NOTE: THE HOT WATER FAUCET HAS A CHILD-SAFETY GUARD ATTACHMENT. Press the safety button on the faucet and then push the faucet handle down. Continue holding safety valve while pushing down faucet handle as long as water is being dispensed. When faucet handle is released, make sure to return it to the original position. CARE AND MAINTENANCE ?Wash the inside of the reservoir with a warm water and baking soda solution. The solution should be about 2 tablespoons of baking soda to a quart of water. The drip tray and water faucets should be cleaned with mild detergent and warm water. TAKING DISPENSER OUT OF SERVICE ?If the water dispenser will not be used for a long period of time, turn both switches OFF (at the rear) and unplug the power cord from the wall outlet. Drain the water from the tanks by removing the caps from the bottom of the dispenser. WARNING--THE WATER COMING OUT OF THE BOTTOM MARKED "HOT WATER DRAIN" MAY BE SCOLDING. 9 PROBLEMS WITH YOUR WATER DISPENSER? You can solve many common water dispenser problems easily, saving you the cost of a possible service call. [. . . ] PARA LIMPIAR LAS PARTES DE PLASTICO SE REQUIERE JABON LIQUIDO Y AGUA TIBIA. NO USE LIMPIADORES ABRASIVOS EN LA SUPERFICIE SUPERIOR NI EN LA BANDEJA DE ESCURRIMIENTO. SI NO VA A USAR EL ENFRIADOR POR UN TIEMPO PROLONGADO DESENCHUFE LA UNIDAD. COLOQUE LOS INTERRUPTORES (10) Y (11) (EN LA PARTE TRASERA) EN LA POSICION "OFF". [. . . ]