User manual AVANTI WCR524SDZD Instruction Manual

[. . . ] BUILT -IN DUAL ZONE WINE CHILLER / VINERA CON 2 ZONAS INSTRUCTION MANUAL MANUAL DE INSTRUCCIONES Model Numbers / No. de Modelos: WC5101DZD / WCR5104DZD / WCR524SDZD (Picture May Vary) BEFORE USE, PLEASE READ AND FOLLOW ALL SAFETY RULES AND OPERATING INSTRUCTIONS. La sección en español empieza en la página 20. Avanti Products has a policy of continuous improvement on its products and reserves the right to change materials and specifications without notice. Avanti Products, A Division of The Mackle Co. , Inc. Box 520604 - Miami, Florida 33152 www. avantiproducts. com APPLIANCE SAFETY Your safety and the safety of others are very important. [. . . ] If you a ttempt to restart before this time delay, the Wine Chiller will not start. When you use the wine chiller for the first time or restart the wine chiller after having been shut off for a long time, there could be a few degrees variance between the temperatur e you select and 12 the one indicated on the LED readout. Once the wine chiller is running for a few hours everything will be back to normal. ?As such the actual number of bottles you may be able to store may vary. NOTE: You can place 32 standard bottles in the upper zone and 14 standard bottles in the lower zone. ?You can turn the interior light on in each zone by pushing the button marked with the "bulb" ?The light will turn off automatically if it remains ON for 10 minutes or more. You have to push the s button marked with the "bulb" symbol again and the light will turn back on. ?The keys are located inside the plastic bag that contains the User's Guide. Insert the key into the lock and turn it counterclockwise to unlock the door. To lock the door do the reverse operation making sure metal pin is engaged completely. SHELVES Appliance WC5101DZD is equipped with the normal wooden shelves and appliance WCR5104DZD is equipped with a pull-out roller assembly (except for the bottom shelf). To prevent damaging the door gasket, make sure to have the door all the way opened when pulling shelves out of the rail compartment. For easy access to the bottles , you must pull the shelves approximately 1/3 out of the rail compartment. 13 ? To remove the shelves out of the rail pull each shelf approximately 1/3 out. Use a long flat screwdriver to press down the right plastic notch as shown in Figure A and at the same time lift the left plastic notch as shown in Figure B. Contact our service department if assistance is needed. Figure A Figure B 14 Normal Wooden Shelves ?To prevent damaging the door gasket, make sure to have the door all the way opened when pulling the bottom shelf out of the rail compartment. For easy access to the storage content, you must pull the shelf approximately 1/3 out of the rail compartment, however this unit was designed with a plastic post on each sides of the shelf track to prevent bottles from falling. When removing the wooden shelf out of the inner rail, make sure to remove all items first. Then move the shelf to the position where the notch of wooden shelf is exactly under the plastic post and lift the wooden shelf. In order to replace the shelf, repeat steps described above in reverse. CARE AND MAINTENANCE ?Turn off the power, unplug the appliance, and remove all items including shelves. [. . . ] Ud necesita programar esa temperatura entre los 58~65ºF (14~18ºC). Si Ud solamente guarda vinos blancos, usted puede colocarlos en cualquier zona pero tendrá que mantener una temperatura entre 55~57ºF (13~14ºC) en la zona superior y una temperatura de 48~55ºF (9~12ºC) en la zona inferior. El indicador marcado "WHITE" se alumbrará en color verde. Cuando Ud guarda vinos espumosos, deberá colocar las botellas en la zona inferior y marcar la temperatura entre los 40~47ºF (5~8ºC). [. . . ]