User manual AUSTRO FLAMM TRIA

[. . . ] Laundry hung up to dry must be kept at a safe distance from the stove because of the danger of fire. General safety instructions for the operation of your stove Thoroughly read the entire manual before starting up your stove and observe the caution notices. Your heating unit may not be moved without approved means of transport with sufficient loadbearing capacity. [. . . ] During the operation of your heating unit it is forbidden to use flammable or explosive materials in the same or an adjacent room to the one in which your heating unit is located Make sure that the load capacity of the supporting construction is sufficient to carry the weight of the entire unit, before the heating unit is installed. For your own safety stringent laws apply for connecting the stove pipes to the chimney. Please have your certified retailer carry out the connection of your stove Being the user of the stove you must take care of a sufficient combustion air supply. Sealed-up windows and doors may not allow a sufficient combustion air supply or disturb the draught behaviour of your stove. Dry, well cured and natural wood (hardwood preferred), wood briquettes. Maximum amount of fuel to be added: 1, 3 kg wood or 1 kg wood briquettes. The wood must be dry (relative wood moisture < 15%) and untreated and the right amount of wood must be burned in order to ensure a clean fire that releases only small amounts of emissions. As soon as the wood logs are burning well, you can regulate the heating capacity with the air slider (slider set to the maximum ("AUF") setting produces maximum heat ­ see figure 2. When adding wood to the fire, follow the same procedure as when igniting the fire: Open the air slider, carefully open firebox door, lay wood on the fire, close the firebox door. Prepare everything you need for starting the fire soft wood chips, igniter materials (such as Austroflamm lighter), wood. Figure 1 provides a good overview of the quantity of the materials you will need. Heating the stove in between seasons, when the outside temperatures are higher, the flue gases may not be able to escape completely and this may lead to disturbances in the chimney draught, especially if the temperatures are rising suddenly. The stove has to be charged with less wood and the primary air has to be increased so that the wood can burn down faster (with visible flames) and thus the chimney flue can stabilize. A chimney fire may occur, due to sooting and deposits in the chimney, if wrong or humid fuel is used. [. . . ] Steel and cast-iron components which show defect in materials or workmanship during the guarantee period shall be replaced with new components. We do not guarantee wearable components (such as Keramott, gaskets, floor grid), surface coatings, lacquer, glass and ceramics. Your AUSTROFLAMM stove was installed by a certified professional and is operated in accordance with the operator's manual. [. . . ]