User manual AUSTRO FLAMM PUR

[. . . ] Placing non-heat-resistant objects on the heating unit or in the vicinity of the heating unit is forbidden. Laundry hung up to dry must be kept at a safe distance from the stove because of the danger of fire. General safety instructions for the operation of your stove Thoroughly read the entire manual before starting up your stove and observe the caution notices. [. . . ] For your own safety stringent laws apply for connecting the stove pipes to the chimney. Please have your certified retailer carry out the connection of your stove. Being the user of the stove you must take care of a sufficient combustion air supply. Sealed-up windows and doors may not allow a sufficient combustion air supply or disturb the draught behaviour of your stove. Your stove was treated with a special environmentally friendly lacquer. The lacquer surface must not be touched when it is heated for the first time. The stove must be initially heated at a high temperature for at least 1. Therefore it will be necessary to open the windows during the initial operation in order let the vapors escape into the outdoors. PLEASE TAKE NOTE: It takes several heating sessions before for your stove releases only the pleasant smell of burning wood. Dry, well cured and natural wood (hardwood preferred), wood briquettes. Maximum amount of fuel to be added: 1, 5 kg wood or 1 kg wood briquettes. The right amount of wood must be burned in order to ensure a clean fire that releases only small amounts of emissions. Figure 4: close the primary air As soon as the wood logs are burning well too, you can regulate the heating capacity with the secondary air slider. (slider set to the maximum ("AUF") setting produces maximum heat ­ see figure 2. ) When adding wood to the fire, follow the same procedure as when igniting the fire: Open primary air, open secondary air, carefully open firebox door, lay wood on the fire, close the firebox door. Prepare everything you need for starting the fire soft wood chips, igniter materials (such as Austroflamm wood lighter), wood. Figure 1 provides a good overview of quantity of the materials you will need. Heating the stove in between seasons, when the outside temperatures are higher, the flue gases may not be able to escape completely and this may lead to disturbances in the chimney draught, especially if the temperatures are rising suddenly. [. . . ] Steel and cast-iron components which show defect in materials or workmanship during the guarantee period shall be replaced with new components. We do not guarantee wearable components (such as Keramott, gaskets, floor grid), surface coatings, lacquer, glass and ceramics. Your AUSTROFLAMM stove was installed by a certified professional and is operated in accordance with the operator's manual. [. . . ]