User manual AURIOL 4-LD2630

[. . . ] - Any appliance that is no longer usable must be neutralised before being thrown away : cut off the power lead. For any repair, take your machine to a registered aftersales service centre, so that the repair will be in accordance with the standards indicated in this instruction book. - Any repair done by an unauthorized person would cancel the warranty. IMPORTANT Never call for steam when the water tank is empty ; you run the risk of damaging the pump. [. . . ] The appliance which you have just purchased complies with the terms of European Directive 73/23 EEC relating to safety and low voltage, and with Directive CEM 89/336/EEC regarding electromagnetic compatibily as amended by 93/68/EEC -5- DESCRIPTION 1 2 3 4 5 6 7 8 9 Description de l'appareil 1. «On/Off» indicator light and steam generator pilot light 4. Connection point for a) flexible hose for accessories b) for optional iron 10. Attach main hose to connection point : a click indicates that it is locked in position. The accessories may be attached to the pistol handle or to an extension tube. NB : when using the rectangular or triangular brush, remember to first insert the curved connector. Move the locking switch to position 2 = fixed position or position 3 = swivel position To release the connector reverse this procedure. Attaching cloth to the rectangular brush Press down on end of clamp ; secure cloth under clamp ; release clamp. To obtain steam, the anti-scale cartridge must be inserted into the water tank. TYPES OF WATER You can use : tap water, distilled water for irons, and water produced by a condenser tumble drier provided that it is filtered (e. Do not use : Rain water, water from the fridge, water from any evaporator appliance, water supplied by your water softener if it indicates that the regenerating salts need replacing (incompatibility with the EMC system). PLEASE NOTE Before each use, ask for steam for a few seconds at the maximum steam setting to remove any water condensation which may be located in the main hose. APPLICATIONS Large Rectangular Brush • For smooth surfaces the cloth should be fixed to the 4 corners. To clean very dirty floors apply the brush directly to the floor without exerting pressure on the bristles : then wipe with the cloth. For varnished parquet flooring, marble floors and delicate floor surfaces, place the cloth under the brush. €¢ Carpets and Fitted Carpets The cloth should be fixed at the 4 corners for normal care. For dirty or very dirty surfaces the cloth should be fixed at the 2 upper corners. Clean by drawing the brush towards you (the steam loosens the dirt, and the bristles of the brush bring it to the surface). NB : before or after steam cleaning, a vacuum cleaner may be used to collect heavier dust. Small Triangular Brush This is used in the same way as the large rectangular brush with the cloth, but is specially suited to small areas, to vertical smoothing and cleaning of fabrics, and to cleaning of small glass surfaces. APPLICATIONS Window Wiper Use the special accessory fitted with the flexible wiper blade. Spray steam over a wide area of glass, and then clean by moving the scraper from top to bottom. [. . . ] The iron does not heat - Appliance not plugged in or On/Off button not up. - The reservoir is empty - The reservoir is incorrectly inserted or has not been inserted. - The anti-scale cartridge has not been inserted - The anti-scale cartridge is incorrectly inserted in the reservoir - The cartridge lifetime pilot light is on - Other - Check the plugs and mains - Go to your local dealer - Plug in the appliance and press the On/Off button. - Go to your local dealer - Press the steam button or the steam trigger on the pistol handle - Fill the reservoir - Insert the reservoir and replace the tank cap - Insert an anti-scale cartridge into the reservoir - Insert the anti-scale cartridge correctly and replace the tank cap - Change the anti-scale cartridge. [. . . ]