User manual AUDIOVOX XMB10

[. . . ] 12 Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 Cleaning the XMB10 Boom Box . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] To increase the 6 volume level, press the + pushbutton; to decrease the volume level, press the - pushbutton. 1 2 3 4 5 NOTE: The Volume buttons on the Remote Control unit (included w/Receiver Combo) will also control the volume output of the Boom Box. Power On/Status/Low Battery LED: The LED lights blue when the Power On/Off pushbutton is pressed to apply power to the XMB10. When operating on AC current, the LED will briefly flash approximately every 10 seconds. When operating on DC(batteries) current, the LED will briefly flash approximately every 5 seconds. The LED will also indicate the status of the volume pushbuttons when the AUX Jack is in use; the LED will flash each time the Volume + or button is pressed until the maximum setting is reached in either direction. Power On/Off Switch: When pressed, applies power to the Boom Box; the power on LED indicator (4) lights blue. EJECT Button: Press this button to release the spring-loaded XMB10 mounting plate to install and remove the Xpress® Receiver from the Boom Box. -6- 128-7546 6 of 16 1. Battery Installation Your Boom Box can operate independently of AC power by installing 8 C-Cell batteries as follows: NOTE: The batteries are bypassed automatically whenever the supplied AC Adapter is plugged into the DC 12V jack on the back panel. COVER LATCHES BATTERY COMPARTMENT COVER NEGATIVE BATTERY COMPARTMENT (COVER REMOVED) POSITIVE NEGATIVE BOTTOM OF BOOM BOX 2. Cabling Interconnections You can begin to enjoy Xpress XM® Satellite Radio as soon as the Receiver and Boom Box Kit installation are complete. Installing the Receiver in the XMB10 Install the receiver as follows: IMPORTANT: Make sure boom box power is off before installing and removing the Xpress Receiver. Press the EJECT button at the top of the XMB10; the spring-loaded mounting plate will tilt forward. RECEIVER COMPARTMENT MOUNTING PLATE EJECT BUTTON MOUNTING PLATE DETENT POSITIVE 1. Push the battery cover latches forward and flip up the battery compartment cover to the open position. Insert eight (8) C-Cell batteries observing battery polarity as shown; then close the cover. CONNECTOR GUIDE PIN Xpress RECEIVER CONNECTOR -7- 128-7546 7 of 16 b. After making sure the connectors and guide pin hole are properly lined up, gently lower the Xpress into the mounting plate, and press down on the Xpress to mate the connectors together. The raised detent on the mounting plate will enter the notch on the rear of the Receiver, indicating the Xpress is properly seated. The receiver should now be attached securely to the mounting plate. c. Apply power to the XMB10 by pressing the Power ON/OFF button; the LED indicator lights blue. If the Receiver does not turn on at the same time, press the Power On/Off ( ) button on the Receiver front panel. Removing the Receiver From the XMB10 Press the EJECT button on top of the Boom Box; the receiver will swing out automatically. Gently grasp each side of the Receiver at the top and pull straight up to disengage it from the mounting plate. Xpress RECEIVER INSTALLED INSTALLING/REMOVING THE Xpress RECEIVER PUSH IN AT TOP TO SECURE IN PLACE -8- 128-7546 8 of 16 Interconnect Diagram RECEIVER BOOM BOX XMB10 ANTENNA JACK (ANT) ANTENNA STORAGE SHELF DC POWER ADAPTER JACK 5. [. . . ] THE EXTENT OF THE COMPANY'S LIABILITY UNDER THIS WARRANTY IS LIMITED TO THE REPAIR OR REPLACEMENT PROVIDED ABOVE AND, IN NO EVENT, SHALL THE COMPANY'S LIABILITY EXCEED THE PURCHASE PRICE PAID BY PURCHASER FOR THE PRODUCT. This Warranty is in lieu of all other express warranties or liabilities. ANY IMPLIED WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY, SHALL BE LIMITED TO THE DURATION OF THIS WRITTEN WARRANTY. ANY ACTION FOR BREACH OF ANY WARRANTY HEREUNDER INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY MUST BE BROUGHT WITHIN A PERIOD OF 48 MONTHS FROM DATE OF ORIGINAL PURCHASE. [. . . ]