User manual AUDIOVOX VOD1021

[. . . ] VOD705 VOD1021 DVD PLAYER WITH DROP-DOWN VIDEO MONITOR ® ELECTRONICS CORP. 128-7092 Release Date: 6-28-04 128-7092 1 of 28 Important Notice An LCD panel and/or video monitor may be installed in a motor vehicle and visible to the driver if the LCD panel or video monitor is used for vehicle information, system control, rear or side observation or navigation. If the LCD panel or video monitor is used for television reception, video or DVD play, the LCD panel or video monitor must be installed so that these features will only function when the vehicle is in "park" or when the vehicle's parking brake is applied. An LCD panel or video monitor used for television reception, video or DVD play that operates when the vehicle is in gear or when the parking brake is not applied must be installed to the rear of the driver's seat where it will not be visible, directly or indirectly, to the operator of the motor vehicle. It is unlawful in most jurisdictions for a person to drive a motor vehicle which is equipped with a screen that is located in the motor vehicle at any point forward of the back of the driver's seat, or that is visible, directly or indirectly, to the driver while operating the vehicle. [. . . ] The audio program connected to the IR2 input can be received on the B channel of the dual channel wireless headphones (P/N IR2CHS). Headset Special Features · Automatic Level Control prevents input signal over loading. · Uses high frequency infrared light to assure a clean signal for clear reception. -15- 128-7092 15 of 28 Wired Headphones There are two 1/8" headphone jacks on the VOD1021 that can be used with any standard wired stereo headphones. These jacks are controlled by the volume up / down buttons on the VOD1021 and on the remote control. Wired FM Modulator The VOD1021 is equipped with an RF modulator, that allows you to listen to the VOD1021 audio signal by tuning your vehicle's radio to the selected frequency, (88. 3, 88. 7, 89. 1, 89. 5, 89. 9, 90. 3MHz). This feature is accessed by using either the FM transmitter buttons on the remote (On/Off, Source Select, Channel Select) or the FM Select button on the unit. Whenever the RF modulator is on, broadcast reception on the vehicles radio will be poor. AV1 Input The video inputs may be connected to a Video cassette Player (VCP), video game system, or any other audio / video device. To access the A/V inputs, turn the VOD1021 on and press the source button on the VOD1021 or the Source button on the remote control until "AV1" is displayed on the screen. Turn the video source component on with its power button or remote control. The VOD1021 is now ready to play the audio and video signals from the source connected to the AV1 input. AUX Input Using the supplied A/V Adapter Cable (P/N 112B3227) the VOD1021 will accept an audio / video input through the 1/8" jack located on the side of the unit. The audio / video device could be a video game system, video camera, or other input device. Video Out The VOD1021 provides a video output for an optional video monitor(s). (Refer to page 6 of the Installation Guide for more details. ) This output will provide a video signal that duplicates the signal displayed by the VOD1021 to an additional monitor or video display. Please see your installer for more information. -16- 128-7092 16 of 28 DVD Basics To get the optimum use out of the DVD section, make sure you read this section completely. Regional Coding Both the DVD player and DVD's are coded by region. The unit will display "WRONG REGION. " Types of Discs your DVD will play · DVD discs ­ DVD discs which contain video. · Audio discs ­ Audio CDs contain musical or sound content only. · MP3 discs ­ A disc that contains audio files (for example, a CD-R with downloaded MP3 files). Loading and Playing Discs Before you load a disc, make sure that it is compatible with the player. Note: the following Discs CANNOT be used with this player : · MiniDisc · Laserdisc · CD-I, CD-ROM, DVD-ROM To load and Play a Disc Press the Power button to turn the unit ON. Select DVD mode and insert the disc (Label Up) into the disc compartment. -17- 128-7092 17 of 28 Settings and Adjustments This chapter describes how to set and how to adjust using the on-screen DVD SETUP menu. Using the Setup Menu Using the setup display, you can do the initial setup, adjust the picture display ratio (16:9 or 4:3) and set the various outputs. [. . . ] Disc won't play · Insert a disc with the label side facing up. If the regional codes don't match, the disc can't be played. Allow player to dry out. Can't advance through a movie · You can't advance through the opening credits and warning information that appears at the beginning of movies because the disc is programmed to prohibit that action. The disc's software doesn't support the feature (e. g. , angles) 3. [. . . ]