User manual AUDIOVOX VME 9312 TS DATASHEET

[. . . ] 9 Care and Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . The unit will also turn 3 SELECT BUTTON (SEL) Press this button to turn the unit DISPLAY CLOCK on automatically when a cassette tape is inserted if the ignition switch is "on". 2increase the volume level, press the/ VOL-) +" side of the VOLUME LEVEL CONTROL (VOL+ To "VOL button. The volume will increase and the level will be shown on the display panel from a minimum of 0 to a maximum of 80. [. . . ] The Seek function can be stopped by pressing the button again or activating any other tuning function. Pressing either side of the button for longer than 0. 5 seconds will cause the radio to continue tuning rapidly in the selected direction until the button is released, at which point it will seek to the next available station. 9 AUTO-STORE SELECTOR (BND) AM/FM BAND TUNING (AS) During radio operation, each momentary press of this button will change the radio band. The indication "AM", "FMI", or "FMII" will appear on the display panel according to your selection. Pressing and holding the button for longer than 2 seconds will activate the Auto-Store Tuning function which will automatically scan the AM or FMII bands and enter strong stations into the pre-set memory positions for that band. If you have already set the pre-set memories on the AM or FMII bands to your favorite stations, activating the Auto-Store feature will erase those stations and enter new ones. This feature is most useful when travelling in a new area where you are not familiar with the local stations. bm feature is used to select the strength of the signals at which LOCAL/DISTANT SELECTOR (LO/DX) This the radio will stop during Automatic Seek Tuning. Pressing and holding the button for two seconds will select the Local setting ("LOC" will appear on the display panel) and only strong (local) stations will be received. Pressing and holding the button again for two seconds will select the Distant setting ("LOC" will disappear from the display panel) and the radio will stop at a wider range of signals, including weaker (more distant) stations. -3- STATION PRE-SET MEMORIES To set any of the 6 pre-set memories in each band, use the following procedure: 1. Select the first station to be pre-set using the Manual Up/Down or Automatic Seek Tuning Controls . After approximately 2 seconds, the display will flash, the volume will be momentarily muted and the pre-set button number (P1, P2, etc. ) will momentarily appear on the display panel indicating that the station is now set into that pre-set memory position. Repeat the above procedure for the remaining 5 pre-sets on that band and for the other 2 bands on the unit. bn bp CASSETTE DOORthe exposed tape edge to the right and Hold the cassette with insert it into the cassette door. Press and hold the Select button approximately 4 seconds until the time display begins flashing. While the time display is still flashing, press the Volume button ( + ) to adjust the hours and the Volume button ( ­ ) to adjust the minutes to the correct time. When the correct time is shown on the display panel, press the Select button again to return to normal display. 3 3 -6- CD CHANGER CONTROLS Built into this unit are controls to operate an optional CD changer. Please check with your Prestige car stereo specialist for recommendations of the models that will work with this unit. Adjustment of the audio functions (volume, tone, balance, and fader) for the CD changer operate in the same manner as they do for radio and cassette play. The following controls will operate the CD changer when it is installed and connected to this unit. Refer to the owner's manual included with the CD changer for instructions on the installation and correct loading and use of the CD magazine. Backward Track Select button (TRK­), the next lower track number will be selected. High-speed audible search to any section of the disc can be made by the Cue and Review functions. Press and hold the TRK+ button to advance rapidly in the forward direction or the TRK­ button to advance rapidly in the reverse direction. During either function, the elapsed time within each track will automatically be shown on the display panel. The Track Select button cp will also select tracks in the shuffled order instead of the normal progression. When all tracks on the disc have been played in shuffled order, the next disc will be selected in normal order and its tracks played in shuffled order. [. . . ] Clean and re-load the disc(s) as appropriate and check for proper operation or try another disc. E-95: Indicates a communication error between the radio and CD changer. The error code will go off and play will resume when the temperature at the changer returns to a normal range. E-99: -8- SPECIFICATIONS: Size: Operating Voltage: Output Power: Output Wiring: 7" W x 2" H x 6-1/8" D 178mm x 50mm x 155mm 12 volts DC, negative ground 160 watts maximum (40 watts x 4 channels) Floating-ground type designed for 4 speaker use. The amplifiers in this unit are NOT designed for use with 2 speakers Compatible with 4-8 ohm speakers AM: 530 - 1, 710 KHz. [. . . ]