User manual AUDIOVOX VIDEO EXPRESS

[. . . ] 00 Features: · · · · The Video Express is a mobile entertainment system designed to be used in motor vehicle applications as well as any 110VAC source. The Video Express is equipped with a cigarette lighter plug to provide power to the 5. 6" LCD TV, Video Player, and an 80W Power Inverter. [. . . ] This is a burn code which states that a specific product will not ignite or will not burn a certain distance at a certain rate of speed as stated in the code. Page 3 of 7 P/N 8000565 Rev. 00 Automotive Installation: 110VAC-12VDC INPUT Remove 12VDC plug from pouch on rear of bag. Secure straps to headrest and base of front seats. Open to desired angle for Video Player. 110VAC-12VDC INPUT Remove 110VDC Power Plug Release kickstand Open to desired angle for Video Player. Adjust flap for desired viewing angle. Above visual is printed on the inside of the Video Express itself. 1. Remove the 12 VDC power cord from the pouch marked 110VAC and 12VDC. This pouch is located on the back side of the Video Express just behind the "kickstand". 110VAC OUTPUT 110VAC-12VDC INPUT 2. Remove the four straps that are packed inside the pocket located on the front of the Video Express. Page 4 of 7 P/N 8000565 Rev. This will help to center the Video Express between the two seats. 4. Use the remaining two straps to secure the bottom of the Video Express bag to the base of the seats Notice: If you route the straps under the seats, make sure that the straps do not interfere with the slide bars of the seat. If the straps get in the way while the seat is being adjusted forwards or backwards, damage to the seat or Video Express could occur. If so, this is the easiest way to route the bottom two straps. Caution: It is unlawful in most jurisdictions for a person to drive a motor vehicle which is equipped with a television viewer or screen that is located at any point forward of the back of the driver's seat, or that is visible, directly or indirectly, to the driver while operating the vehicle. This product should only be installed to the rear of the back of the driver's seat where it will not be visible, directly or indirectly, to the operator of the motor vehicle. Note: All four straps must be installed properly. Failure to do so could cause the Video Express to break loose in a collision and cause bodily injury or damage to the Video Express itself. Page 5 of 7 P/N 8000565 Rev. 00 TV and VCP Adjustments: Visuals are printed on the inside of the Video Express itself. [. . . ] This is especially true if you are installing the Video Express into different types of vehicles. Each vehicle's seats will have a different angle to them. Page 6 of 7 P/N 8000565 Rev. [. . . ]