User manual AUDIOVOX UV 8

[. . . ] Subject to technical changes We hope you will find the instructions in this owner's manual clear and easy to follow. If you take a few minutes to look through it, you'll learn how to use all the features of your new Audiovox UV8 Mobile Multimedia Receiver for maximum enjoyment. Subject to technical changes It's a good idea to read all of the instructions before beginning the installation. Burn up to 1500 MP3 and WMA Files onto a DVD+R / RW · Heat Management System - Forced Air-Cooling to keep The Chip-Sets Operating at Nominal Temperatures General · Subject to technical changes Tools and Supplies You will need these tools and supplies to install your UV8: · 16 ­ 18 gauge speaker wire Disconnecting the Battery To prevent a short circuit, be sure to turn off the ignition and remove the negative (-) battery cable prior to installation. [. . . ] Using Preset Stations Six numbered preset buttons store and recall stations for each band. Touch the preset number in which you would like to store the current station (or press EXIT to cancel and close the menu). Subject to technical changes Push the MEM on-screen button and then select the desired preset (P1- P6) 3. the VME start scanning the available broadcasters (which take a while) 3. Once scanning is finished the 6 strongest ones will be stored at P1- P6 4. During Automatic Storing (AS) only the frequencys will be stored at P1- P6 to decrease the scanning/ storing time 5. If you now manually select P1- P6, then the PS information will be finally stored for the selected preset (i. Not all broadcaster support this additional information or all the time Preview Scan (PS) To scan the AM or FM band for a preview of available stations in your particular area, touch the 1/2 button to access the second screen of menu options touch the PS button (21). Subject to technical changes Local Radio Station Seeking (LOC) When the Local function is on, only radio stations with a strong local radio signal are played. To activate the Local function in AM/FM tuner mode, touch the 1/2 button to access the second screen of menu options, and then touch the onscreen LOC button. DVD/VCD VIDEO OPERATION NOTE: When properly installed, DVD video cannot be displayed on the main TFT screen unless the parking brake is applied. If you attempt to play a DVD while the vehicle is moving, the TFT screen displays "PARKING" with a blue background. Closing the TFT Screen Press the OPEN button (1) again to close the TFT screen. NOTE: If Parental Lock (Rating) is activated and the disc inserted is not authorized, the 4-digit code must be entered and/or the disc must be authorized (see "General Sub-menu Features" on page 64 ) . You cannot insert a disc if there is already a disc in the unit or if the power is off. NOTE: DVD-R and DVD-RW will not play unless the recording session is finalized and the DVD is closed. Accessing DVD Mode To switch to DVD mode when a disc is already inserted, press the SRC button (6) on the front panel or remote control (8) until "DISC" appears at the bottom of the screen. controlling Playback To access the on-screen controls , touch the screen. Subject to technical changes Slow Motion Playback Press the << button (22) on the remote control, the V button (11) on the joystick, or the << button on the screen to play the current title in slow motion. Keep pressing and releasing the button to increase the rate from "2X" to "4X", "8X", and "20X". Press >/|| (18) on the remote control or touch the onscreen play button (>) to resume normal play. fast Forward Playback Press the >> button (14) on the remote control , the /\ button (15) on the joystick , or the >> button on the screen to fast forward. [. . . ] Subject to technical changes GENERAL Unit will not power on Radio Fuse blown Car battery fuse blown Illegal operation Install new fuse with correct rating Install new fuse with correct rating Press the RESET button located in the bottom right corner of the front panel Replace battery with new one Remove battery and install correctly Check wiring and correct Increase volume level Review wiring diagram and check "MUTE" connection Replace speakers Adjust the channel balance to the center position Insulate all speaker wiring connections Use original copy Connect proper speakers Check speaker contact Check that the "MUTE" connection is not grounded and that it's properly insulated Check wiring and correct Battery depleted Battery installed incorrectly Improper audio output connection Volume set too low Improper "MUTE" connection Speakers damaged Heavily biased volume balance Speaker wiring is in contact with metal part of car Pirated disc is in use Speaker power rating not compatible with unit Speaker is shorted "MUTE" wire is grounded Incorrect connection between ACC and positive battery wire Tel-Mute malfunction Unit resets itself when engine is off TFT Auto Open is turned off Incorrect connection to parking brake wire PRK SW is activated, parking brake is not engaged Turn TFT Auto Open on Check wiring and correct Stop vehicle in safe place and apply parking brake DVD is not compatible with current TV system settingsChange setup to accommodate disc Improper video signal connections Check wiring and correct Use correct aspect ratio setting Press OPEN key to restart monitor movement TUNER Weak station searching Auto antenna is not fully extended Auto antenna not properly connected LOCAL function is activated Disc is warped or scratched Disc is dirty or wet Laser pickup is dirty Incompatible disc is used Disc rating exceeds Parental Lock rating limit Disc region code is not compatible with unit Disc is inserted upside down Subject to technical changes Connect the auto antenna control cable properly Connect the auto antenna control cable properly Turn LOCAL function Disc does not play back Use disc in good condition Clean disc with soft cloth Clean laser pickup with cleaning disc Use compatible disc Change Parental Lock settings to lower restriction Use disc with proper region code Image blurred, distorted, or dark PCB cannot be used during No repeat or searching MP3 Interruption occurred during playback Use original disc PCB is not available on the disc PCB is on Turn PCB off Clean disc or replace Recreate disc with good files Message is longer than LCD can display Disc is being read Disc is dirty Disc is upside down Disc not present in loading compartment Disc is dirty Disc is upside down Disc format is not compatible with this unit DVD is not compatible with region code of unit Illegal mechanism operation Clean disc with soft cloth Insert disc with label side up Insert disc Clean disc with soft cloth Insert disc with label side up Press EJECT key for 5 seconds to reset loading mechanism Subject to technical changes Use only a clean silicone cloth and neutral detergent to clean the front panel or monitor. A rough cloth and nonneutral detergent (such as alcohol) may result in scratching or discoloration. If the temperature inside the player gets too hot, a protective circuit automatically stops play of the disc. If this occurs, allow the unit to cool before operating the player again. [. . . ]