User manual AUDIOVOX TV32

[. . . ] If any part of the antenna makes contact with overhead power lines, touching the antenna or the antenna cable can cause electrocution and death. If the antenna is in contact with any type of overhead wires, call your power company and ask them to send a qualified technician to remove the antenna. Important Safety Precautions: Many do-it-yourself and professional antenna installers are injured or killed each year by electric shock. [. . . ] Slide the spade lugs of the matching transformer between the washer and tighten the wing nuts securely. Mount the TV32 antenna on top of the mast and lightly tighten the two mast clamps. You will probably need a helper to view the TV set while you are rotating the antenna. Secure the coaxial downlead to the mast (using cable ties) to prevent it from whipping by the wind. Ground the antenna and mast per the accompanying grounding instructions. (See page 13. ) 3 4 T0278-TV32-. qxp 7/11/03 04:20 PM Page C6 Antenna Assembly (continued) General Installation Instructions for Mast Mounted Antennas TV32 TV32 Elements Boom Point Towards TV Stations Downlead Connection Mast Clamps 1. Assemble your antenna on the ground at the installation site per the instructions. Pull enough coax downlead and connect to the antenna per its instructions. To insure that the mast does not fall, a durable nonconductive rope should be attached to each ten foot section as it is raised. If you are using guy wire installation (not included) instead of a mounting bracket: · Install guy anchor bolts. Carefully take the antenna and mast assembly to the mounting bracket and insert. In case of a guyed installation, it will be necessary to have at least a second person hold the mast upright while the guy wires are attached and tightened to the anchor bolts. NOTE: Point the antenna towards the station broadcast tower ­ look at a neighbor's outdoor antenna for help in locating the direction of the tower. You will probably need a helper to view the TV set while you are rotating the antenna. 5 Mast 6 T0278-TV32-. qxp 7/11/03 04:20 PM Page C8 Where To Install Your Antenna Types of Support Structures and Mounting TV32 TV32 Before attempting to install your antenna, decide on the best location to install your antenna for both safety and performance. Most antennas are supported by tripod masts or pipe masts attached to the chimney, roof, or to the side of the house. Good practice is to install your antenna about 5 to 10 feet above the roof line and away from power lines and other obstructions. [. . . ] The Tripod mount must be securely anchored to the roof as should the guy wires. Apply roofing compound around the base of the brackets, screws and eyebolts to weather proof the holes in the roof. If not, install wood plates in the attic and install bolts to secure the mount. [. . . ]