User manual AUDIOVOX PADIN2

[. . . ] 4) VCP Installation a) VCP can be mounted in the following methods: 1. Double side tape, minimum thickness 0. 187" dual lock Velcro applied to bottom of VCP. b) Connect the Video out (yellow terminal) to male RCA connector (color coded yellow). [. . . ] If a 10°wedge base is used, be sure shroud is flush to all edges prior to attaching velcro. o) Clean internal surface of padded shroud with 70% isopropyl alcohol. p) Place two 1" x 1" and 1"x 2" pads of " dual lock" velcro on padded shroud (as located in step n) above. q) If necessary place 10°wedge base over monitor/bracket assembly and push four pads of velcro together, being sure all four pads are fully engaged with pads on monitor. r) Repeat above steps for each additional monitor location. PTT Green SWITCHCRAFT A4F CONNECTOR MIC (+) White MIC (-) Black PTT Red Microphone Pin View Figure 1 3 Front PADIN2 Features Figure 2 1) Bass Control Knob- Turn knob clockwise to increase bass and counterclockwise to decrease bass. 3) Treble Control Knob- Turn knob clockwise to increase treble and counterclockwise to decrease treble. 5) VCP- This button switches the PADIN2 to VCP and also triggers the monitor. An additional push of this button will toggle back and forth between the internal and external paging system. VCP Controls NOTE: For these controls to function, the IR repeater/emitter must be installed over the IR window on the VCP. 11) Stop- This button stops the tape when it is in " play"or another mode. 12) REW- This button will rewind the tape when it is in " play" or " stop" mode. 13) Replay- This button will stop the tape and rewind back to the beginning of the tape and resume play mode. Switchcraft D4M Connector Philmore T609CB Connector Microphone Cable Adapter Figure 3 4 Rear PADIN2 Features Ext. Spkr (-) 2 3 4 Radio Input R (+) Radio Input L(+) Audio From VCP (+) R Int. Spkr (+) IR (+) IR (-) Monitor Trigger Ground Audio From VCP (-) Figure 4 1) MIC Gain- These controls are accessed through the control in rear. [. . . ] b) See Table 1 and Figure 8 for customer insertion view and harness color code. 4) Monitor Fuse*Replacement fuse should be a 5 Amp automotive glass fuse* Do not replace with a higher or lower rated fuse. An over rated fuse will allow excessive current draw to damage the monitor. [. . . ]