User manual AUDIOVOX NEXTGEN INSTALLATION

[. . . ] If unit does not operate, recheck all wiring until the problem is corrected. Once proper operation is achieved, turn off ignition switch and proceed with final mounting of the chassis. 4) Locate the series of bend tabs along the top, bottom, and sides of the mounting sleeve. [. . . ] To exit the configuration menu press AUDIO ADJUST or let the menu timeout, within about 5 seconds. Country Code 11 12 Country North America Europe Band AM FM SW AM FM LW AM FM AM FM AM FM AM FM AM FM Low 530 87. 9 5900 531 87. 50 144 531 87. 5 522 76. 0 530 88. 0 530 87. 9 531 87. 5 High 1710 107. 9 6200 1629 108. 00 288 1629 108. 0 1629 90. 0 1600 108. 0 1620 107. 9 1602 108. 0 Step 10kHz 200kHz 5kHz 9kHz 50kHz 9kHz 9kHz 100kHz 9kHz 100kHz 10kHz 100kHz 10kHz 200kHz 9kHz 50kZHz 13 14 15 16 21 Pacific Japan Latin America Brazil Saudi Arabia CONFIGURATION OF 2 AND 4 SPEAKER OPERATION Hold down the AUDIO ADJUST button for longer than 3 seconds. Press the manual "tune down/track down" button until you see "SP--**" displayed on the readout (where ** can equal 2 or 4). Depending upon your setup, you'll change this menu item accordingly, using the manual "tune down/track down" button to modify the setting to either "SP-2" or "SP-4". Once configured to your particular setup, exit the configuration menu by pressing the AUDIO ADJUST or letting the menu timeout, within about 5 seconds. 6 CONFIGURATION- con't. CONFIGURATION OF TUNER SEEK SENSIVITY SETTING The scan sensitivity feature is designed to give flexibility during the tuner seek function. The tuner can be configured such that during seek, it will stop on strong stations, ignoring weaker signals. To configure the seek sensitivity setting, hold down the AUDIO ADJUST button for longer than 3 seconds. While in the general configuration menu, press preset 4 and then preset 2. Press the manual "tune down/track down" button until you see "SC--**" on the display (where ** can equal 00-15). The numbers are set such that at the setting "SC-00", the unit is more sensitive to weaker signals. This means that the seek function will stop at most or all weak signals. At "SC-15", the seek function will stop only at the strong stations. Use the manual "tune up/track forward" button to adjust the seek sensitivity of the tuner to a setting that will suit the application. To exit the tuner configuration menu, press AUDIO ADJUST or let the menu timeout, within about 5 seconds. CONFIGURATION OF THE MECHANICAL CASSETTE MODULE Hold down the AUDIO ADJUST button for longer than 3 seconds. Press manual "tune down/track down" button until you see "IN--**". For logic cassette, scroll through the menu options until "IN--**" (where ** can equal NA, LT, CD, or CG) is displayed. For proper mechanical cassette operation, this setting should be set to "IN-NA". [. . . ] For installation of CD module (NGMCD2), follow steps 1-3 on page Insert the CD Module into the Nextgen chassis until it clicks in place. CD2. Connect the 14-pin connector from the CD module to the Nextgen chassis on the bottom left corner 14-pin socket. CD3. Connect the 4-pin connector from the Nextgen CD Module to the 4pin socket on the backside of the faceplate. 11 CD4. [. . . ]