User manual AUDIOVOX MSR3007

[. . . ] MSR3007 MARINE AUDIO SYSTEM Installation and Operation Manual POWER MSR3007 VOLUME EQ IX BASS AUDIO MENU MODE CAT SEL CAT + INFO SCROLL TUNE/TRK SEEK SEEK TUNE/TRK VOLUME BAND 40W x 4 SEARCH AUX IN MUTE 1 2 INT 3 RPT 4 RDM 5 6 AS/PS MSR3007 SAFETY INFORMATION When Boating Keep the volume level Iow enough to be aware of your surroundings. Protect from Water Do not expose the product directly to water, as this can cause electrical shorts, fire or other damage. Protect from High Temperatures Exposure to direct sunlight for an extended period of time can produce very high temperatures inside your vessel. Use the Proper Power Supply This product is designed to operate with a 12 volt DC negative ground battery system. [. . . ] Balance Use the VOLUME buttons to adjust the Balance between the left and right speakers from "L12" (full left) to "R12" (full right). Fader Use the VOLUME buttons to adjust the Fader between the rear and front speakers from "R12" (full rear) to "F12" (full front). Volume Level Use the VOLUME buttons to adjust the Volume level. VOLUME BAND 40W x 4 SEARCH AUX IN 1 2 INT 3 RPT 4 RDM 5 6 AS/PS 17 18 14 8 6 5 7 9 10 16 15 19 Power On/Off Press any button on the front panel to turn the unit on. · · · If a disc is being inserted when the radio power is off and the ACC (accessory switch) is on, the unit will automatically power up and playback will start. If a CD is present, playback resumes at the last position in memory before the ignition was turned off or the POWER button was pressed. If no CD is present, the unit will resume at the last mode selected (Tuner, Aux, etc. ). The POWER button is illuminated whenever the IGN lead (red wire) is powered, regardless of whether the unit is on or off. Volume Control To increase the volume, press the VOLUME + button (2a). To decrease the volume, press the VOLUME - button (2b). System Menu 1. Press and hold the AUDIO button (3) for more than 3 seconds to enter the system menu. "MENU" will appear on the display, followed by the first menu item, "CONTRAST. " Press the TUNE/TRK >>| or |<< button (21, 20) or press the AUDIO button repeatedly to navigate the system menu and select the desired item. Press the AS/PS button to return to the previous operation immediately or wait for 5 seconds to return automatically. MWR100 (ON/OFF): Enable or disable MWR100 external wired remote operation. AREA (USA/LATIN/EUROPE/OIRT): Set frequency spacing for various regions. BEEP TONE (ON/OFF): Turn the audible beep ON/OFF (heard when functions/buttons are selected). RESUME: Return the EEPROM to factory default set up values and reset the Sirius Tuner Settings. Press MODE to select. Mute Press the MUTE button (17) on the control panel to mute the audio output. Press MUTE again to restore the audio output to the previous level. Mode Press the MODE button (4) on the control panel to select a different mode of operation, as indicated on the display panel. Available modes include Tuner, SIRIUS, CD, iPod and AUX In (optional Auxiliary Input). NOTE: CD, CDC, IPOD, or SIRIUS mode will be skipped if the module is not installed. The following items can be adjusted: · · · · · · · Reset The reset button should be activated for the following reasons: · · initial installation of the unit when all wiring is completed function buttons do not operate 5 MSR3007 LOW BATTERY Operation If LOW BATT is set to "ON", a alarm will sound (8 beeps every 30 sec) when the voltage drops to 10. 8V (+/- 0. 03V). A visual warning (LOBA) will appear flashing (8 flashes every 30 sec) in the lower left corner of the LCD display. Press a preset button (5-10) to select the corresponding stored station. Automatically Store / Preset Scan (AS/PS) Automatically Store Select a band (if needed). Press and hold the AS/PS (15) button for more than three seconds to automatically select six strong stations and store them in the current band. [. . . ] Selecting Tracks During playback, press the TUNE/TRK |<< / >>| button (20/21) to play the previous or next track in the current category. Press the TUNE/TRK |<< button (20) once to play the song from the start position or press TUNE/TRK |<< twice to play the previous track. Press and hold the TUNE/TRK |<< / >>| button (20/21) to fast reverse/forward the song. NOTE: If you press and hold the TUNE/TRK |<< / >>| button to change the current song to the previous/next song, you will exit fast reverse/forward mode. Alternate Display Information Press INFO/SCROLL button (12) to change the display information in the following order: ARTIST NAME > SONG TITLE > FOLDER NAME. 10 MSR3007 CARE AND MAINTENANCE · · · · · Keep the product dry. [. . . ]