User manual AUDIOVOX MCDA1

[. . . ] This unit is designed to be operated only on +12 volt DC negative ground systems; it cannot be used on +24 volt or positive ground systems. Although it is designed to be water resistant, the unit will leak if the enclosure is damaged or subjected to high pressure spray. When considering a mounting location, effort should be made to select an area that is least exposed to an outdoor environment. Since extreme temperatures affect operation, the unit is equipped with a built in self-protection circuit that halts operation when the temperature reaches a preset level. [. . . ] The required mounting depth will vary, but at least 2 1/2" is needed to mount the controller. If a standard cutout is not available, mark an area for the cutout and carefully cut a 2 1/8" opening with a hole saw. A jig saw can be used but may cause difficulty because of the small radius of the opening. Be sure to check behind the panel for wiring harnesses, steering cables, hydraulic lines, fuel lines, gas tanks, etc. Also check to make sure you can get behind the dash panel, bulkhead, etc. Finally, route the remote control cable through the mounting plate and base, and attach the remote to the plastic mounting plate by aligning the four hooks on the holder with the four slots on the remote. Once the remote has been mounted, connect the cable to the main unit using the 20 foot extension cable supplied. Up to two additional extension cables (MWREXT) may be purchased and used to extend the reach of the remote up to 60 feet. When connecting the cables, be sure to route the extension cable away from sharp objects, corners and places where it might get pinched, as this could affect performance and cause damage to the unit. Grip the tab on the magazine tray into which you will be loading a disc, and pull it out gently. Insert one disc into the tray with the label side up (play surface facing down). Load additional discs into the remaining nine trays in a similar manner. NOTE: This unit is not designed to play 3" (8cm) CD-Single discs. Inserting a 3" disc into the magazine, either with or without a 3" disc adaptor, can damage the changer and the disc. To remove a disc from the magazine, pull out the tray of the disc to be removed, lift out the disc, and push the tray back into the magazine. Making sure the top of the magazine is facing upward, gently insert it into the unit until it clicks into place. The magazine will not lock into place unless the power supply has already been connected. NOTE: Be sure to keep the front panel closed at all times when not loading or removing the magazine. Leaving the panel open could allow dust, dirt and moisture to enter the changer, which could cause the unit to malfunction. Press DIM (6) for more than three seconds to adjust the LCD between a dim and a bright display. Press MODE (9) for more than three seconds to activate or deactivate the subwoofer output. When in CDC mode, press and hold AS/PS (10) for more than three seconds to select ESP ON/ OFF and improve the sound quality. [. . . ] Press DISP (29) to display information such as the clock, ID3 tag, song title, directory name, artist name and other information. Press RPT (31) for more than three seconds to continously repeat the same track. Press the button again for more than three seconds to resume normal play. Press RDM (32) for more than three seconds to play all tracks on the current disc in random order. [. . . ]