User manual AUDIOVOX MCD5070

[. . . ] Consult with your nearest dealer if installation requires the drilling of holes or other modifications to your vehicle. Install the unit where it does not interfere with driving and cannot injure passengers if there is a sudden or emergency stop. If the installation angle exceeds 30º from horizontal, the unit might not give optimum performance. [. . . ] Re-attach the front panel to the chassis and test radio operation by referring to the operating instructions for the unit. Insert fingers into the groove in the front of frame and pull out to remove the frame. (When re-attaching the frame, point the side with a groove downwards and reattach. ) Insert the removal keys straight back until they click, and then pull the radio out. If removal keys are inserted at an angle, they will not lock properly to release the unit. Important Notes DIN Front/Rear Mount This unit can be property installed with either a "Front" (conventional DIN front mount) or "Rear" (DIN rear mount installation, utilizing threaded screw holes at the sides of the unit chassis) mount. Remove the detachable front panel, if it is Dashboard attached to the chassis, by pushing the Bend Tabs REL button. Slide the mounting sleeve off of the chassis if it has not already been removed. 53 If it is locked into position, use the removal Screw Stud keys (supplied) to disengage it. The removal keys are depicted in "Removing the Unit" on page 3. Check the dashboard opening size by sliding the mounting sleeve into it. If the opening is not large enough, carefully cut or file as necessary until the sleeve easily slides into the opening. Check that there will be sufficient space behind the dashboard for the radio chassis. Locate the series of bend tabs along the top, bottom and sides of the mounting sleeve. With the sleeve fully inserted into the dashboard opening, bend as many of the tabs outward as necessary to firmly secure the sleeve to the dashboard. Place the radio in front of the dashboard opening so the wiring can be brought through the mounting sleeve. Dashboard 2. Removal Key Trim Plate Installation Push the trim plate against the chassis until it is fitted. You must do this before you install the control panel, otherwise it can't be attached. 3 MCD5070 DIN Rear Mount (Method B) This unit has threaded holes in the chassis side panels which may be used with the original factory mounting brackets of some vehicles to mount the radio to the dashboard. Please consult with your local mobile stereo shop for assistance on this type of installation. [. . . ] 40W x 4 No sound TROUBLESHOOTING Symptom No power Cause The vehicle's ignition is not on The fuse is blown Solution If the power supply is properly connected to the vehicle accessory terminal, switch the ignition key to "ACC". If the error code does not disappear, consult your nearest service dealer. If the error code does not disappear, consult your nearest service dealer. Disc cannot be loaded or ejected Presence of CD disc inside the player Inserting the disc in reverse direction Compact disc is extremely dirty or disc is defective Temperature inside the vehicle is too high Condensation Volume is too low Wiring is not properly connected. The operation keys do not work Control panel not properly installed The built-in microcomputer is not operating properly due to noise Sound skips The installation angle is more than 30 degrees. [. . . ]