User manual AUDIOVOX MCD5060

[. . . ] NOTE: CD-R and CD-RW discs will not play unless the recording session is closed and the CD is finalized. Audio CD RECORDABLE REWRITABLE DISC NOTES Compatible Disc Types Table 1: General Disc Information Disc Type Logo Diameter/ Playable Sides 12 cm single side Playback Time 74 minutes Disc Maintenance · A dirty or defective disc may cause sound dropouts while playing. Before playing, wipe the disc using a clean cloth, working from the center hole towards the outside edge. Never use benzene, thinners, cleaning fluids, anti-static liquids or any other solvent. Insert label side up. Do not bend. Never touch the under side of the disc. Wipe clean from the center to the edge. · · · Be sure to use only round CDs for this unit and do not use any special shape CDs. [. . . ] Place the radio in front of the dashboard opening so the wiring can be brought through the mounting sleeve. secure part of the dashboard Screw Stud Hex Nut (5mm) either above or below the radio using the screw and plain Spring Washer washer provided. CAUTION: The rear of the radio must be supported with the strap to prevent damage to the dashboard from the weight of the radio or improper operation due to vibration. Re-attach the front panel to the chassis and test radio operation by referring to the operating instructions for the unit. Insert fingers into the groove in the front of frame and pull out to remove the frame. (When re-attaching the frame, point the side with a groove downwards and reattach. ) Insert the removal keys straight back until they click, and then pull the radio out. If removal keys are inserted at an angle, they will not lock properly to release the unit. Dashboard 2. Removal Key Trim Plate Installation Push the trim plate against the chassis until it is fitted. You must do this before you install the control panel, otherwise it can't be attached. 3 MCD5060 DIN Rear Mount (Method B) This unit has threaded holes in the chassis side panels which may be used with the original factory mounting brackets of some vehicles to mount the radio to the dashboard. Please consult with your local mobile stereo shop for assistance on this type of installation. Remove the existing factory radio from the dashboard or center console mounting. Save all hardware and brackets as they will be used to mount the new radio. Carefully unsnap the plastic trim ring from the front of the new radio chassis. Remove the factory mounting brackets and hardware from the existing radio and attach them to the new radio. Select a position where the screw Screws holes of the bracket and the screw holes of the main unit Dashboard are aligned (are fitted). Longer screws Bracket may damage components Hook (Remove) inside the chassis. Wire the new radio to the vehicle as outlined in the Universal Installation instructions. Mount the new radio assembly to the dashboard or center console using the reverse procedure of step 1. · The DCP can easily be damaged if dropped or subjected to a strong shock. When the release button is pressed and the DCP is unlocked, the vehicle's vibrations may cause it to fall. To prevent damage to the DCP, always store it in a protective case after detaching it. The rear connector that connects the main unit and the DCP is an extremely important part. Be careful not to damage it by pressing on it with fingernails, pens, screwdrivers, etc. You can use a cotton swab soaked in isopropyl alcohol to clean the socket on the back of the DCP. · · 4. [. . . ] Press 2/INT again to stop Intro Scan and resume normal play at the current track. Repeat Play (3/RPT) Press the 3/RPT button (14) during disc play to repeat play the current track. Press 3/RPT again to stop repeat play Random Play (4/RDM) Press the 4/RDM button (15) on the control panel during disc play to play all tracks on a CD in random, shuffled order. Press 4/RDM again to stop random play. 8 MCD5060 SPECIFICATIONS CD Signal to Noise Ratio. [. . . ]