User manual AUDIOVOX MCD5050

[. . . ] Torx type, Flat and Phillips screwdrivers Wire cutters and strippers Tools to remove existing radio (screwdriver, socket wrench set or other tools) Electrical tape Crimping tool Volt meter/test light Crimp connections 18 gauge wire for power connections 16-18 gauge speaker wire Speakers with a load impedance less than 4 ohms could damage the unit. The following tips will help you determine the best location for mounting the unit: · Select a location that does not interfere with the normal functions of the driver and will not cause injury to the driver or a passenger in the event of a sudden stop or other emergency. Do not install the unit in a location that would subject it to high temperatures (such as in direct sunlight or next to a heating unit), dust, dirt or excessive vibration. If the installation angle exceeds 30 degrees from the horizontal, the unit may not function optimally. [. . . ] Once this feature is activated, press SEL/MENU momentarily to step though the available menu options. When no adjustments have been made for five seconds, the unit will resume normal operation. The following options are controlled through the menu feature: Press SEL/MENU for more than three seconds to access the menu feature. When "BEEP ON/ OFF" appears in the display, press VOL or VOL to turn the audible beep on or off. When this feature is turned on, the unit will beep each time a button is pressed. Turning off this feature disables the audible beep, and no beep will be heard when pressing buttons. Press SEL/MENU for more than three seconds to access the menu feature. When "BEEP ON/ OFF" appears in the display, press SEL/MENU one time, then press VOL or VOL to select the volume level for the unit to assume each time it is turned on. This option allows a selection between USA (200k for FM and 10k for AM) and European (50k for FM and 9k for AM) radio frequency spacing. Press SEL/MENU for more than three seconds to access the menu feature. When "BEEP ON/OFF" appears in the display, press SEL/MENU two times, then press VOL or VOL to select USA or European spacing. Press LOUD (7) for more than three seconds to reinforce the bass output. Press BAND again for more than three seconds to release this function. Use a ballpoint pen or other thin metal object to press the reset button (9) under the following circumstances: · If none of the function buttons work or if an error symbol appears in the display. Press CHANNEL << (11a) or CHANNEL >> (11b) momentarily, and the unit will automatically tune to the next strong station. Press CHANNEL << or CHANNEL >> for more than three seconds to enter manual tuning mode. When "MANUAL" appears on the display, press CHANNEL << or CHANNEL >> to move the radio frequency up or down one step. To automatically select six strong stations and store them in the current band, select a band (if needed) and press AMS (13) for more than three seconds. [. . . ] Do not stick paper, tape or any other substance to either side of the CD, as it may cause the disc to malfunction. Protect CD's from dirt, dust, scratches and warping, as these may cause malfunction. refer to the manual for the CD-R/CD-RW recorder or software for information on the finalization process. Depending on the recording status, recording equipment and disc conditions, some CD-R and CD-RW discs may not play on this unit. [. . . ]