User manual AUDIOVOX GMRS120 Owners Manual

[. . . ] When in function edit mode this button will be used to adjust the unit's settings. Down Channel/Volume Button (11) In the standby mode, pressing this button will decrement the listening volume. When in function edit mode this button will be used to adjust the unit's settings. MODE Button (9) Press this momentarily to select various feature settings in the GMRS and FRS modes. [. . . ] Channel Selection In order to communicate with other GMRS/FRS units, both transmitting and receiving party must be on the same frequency. The GMRS120/120-2 has 22 channels (frequencies) (1-22) indicated by the large digits on the LCD display panel. Channels 8-14 are FRS only channels, while channels 15-22 are assigned GMRS only channels. Communication with Audiovox GMRS/FRS and compatible units is possible on these 22 channels. To change the channel, - From GMRS/FRS standby mode, press the MODE button (9) until the channel number flashes. - Press the Up Button (10) briefly to move to the next higher main channel number. - Press the Down Button (11) briefly to move to the next lower main channel number. MODE VOX ( ON/OFF) NOTE: Refer to the appropriate section of this manual for detailed operating instructions for each mode. Controls: Power On/Off and SCAN (6) Button Press and hold the power on/off button ( ) for at least 2 seconds. To turn the unit off, press and hold the button for at least 2 seconds. Adjusting the Volume (10, 11) With the unit powered on, press the Up Channel/Volume button ( ) to increase volume and the Down Channel/Volume button ( ) to decrease volume. The display will indicate the current volume level by the icon ( UL 0-7 ). VOX Selection Mode This option enables you to have hands-free conversation. Your voice or nearby sound is detected and the radio transmits without the need to press the PTT button. To set radio for VOX operation, -From GMRS/FRS standby mode, press and hold the MODE button until the VOX icon appears on the display. Channel Scan Operation This feature allows you to monitor all channels automatically for valid signals. When a signal is received, the scan is interrupted and will return to scan mode 5 seconds after reception is terminated. NOTE: While the scan function is active, the MODE button will be inoperative. The scan mode will reduce the overall battery life due to the battery save function is overridden. To enable the channel scan mode, - From GMRS/FRS standby mode, momentarily press the power Button; (SCAN) will appear on the LCD display. - The radio will display each channel (1-22) in order as the scan mode operates to find an active main channel. - When unit doesn't find any signals and you want to transmit, press the PTT switch to return to home channel operation. The transceiver will automatically resume scanning approximately 5 seconds after the communication is completed. - If there is no activity and you want to leave the scan mode, press the power button momentarily and the unit will return to normal operation; (SCAN) icon will disappear from the LCD display. Warning · Do not operate the transceiver unless you are licensed to do so. · Remove the batteries from the transceiver if it is not expected to be used for long periods. [. . . ] This Warranty is in lieu of all other express warranties or liabilities. ANY IMPLIED WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY, SHALL BE LIMITED TO THE DURATION OF THIS WRITTEN WARRANTY. ANY ACTION FOR BREACH OF ANY WARRANTY HEREUNDER INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY MUST BE BROUGHT WITHIN A PERIOD OF 30 MONTHS FROM DATE OF ORIGINAL PURCHASE. IN NO CASE SHALL THE COMPANY BE LIABLE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES FOR BREACH OF THIS OR ANY OTHER WARRANTY, EXPRESS OR IMPLIED, WHATSOEVER. [. . . ]