User manual AUDIOVOX FR-114-2

[. . . ] Holding the button will continuously advance channels until the button is released. Channel Down Button (CH ): Pressing this button momentarily decreases 1 channel. Holding the button will continuously decrease the channels number until the button is released. Call Button: Press to send a ringing sound to other radios tuned to the same channel. [. . . ] Pressing any of the buttons will exit the battery saver mode and illuminate the display. -7- USING YOUR FR-114-2 Turning the Transceiver on Rotate the POWER ON /OFF-VOLUME CONTROL clockwise to turn on the transceiver and increase the listening volume level. The speaker will play a confirmation beep tone to confirm the transceiver's activation. To turn the unit off, rotate the POWER ON /OFF-VOLUME CONTROL counterclockwise. Button Conformation Tones Whenever, the Channel Up Button (CH ) or Channel Down Button (CH ) buttons are pressed, the speaker will play a tone to confirm each press. When adjusting the channel number, the tone will correspond to the current setting, the lower the tone, the lower the channel selected. Low Battery Alert When the batteries are in need of replacement, the low battery indicator LED will light. -8- To Select a Channel Press and release the Channel Up Button (CH ) or the Channel Down Button (CH ). A unique tone will be played to confirm each channel selected and the current channel setting will be shown on the display. When the highest or lowest channel is reached, the channel setting will wrap around and repeat the selection. Holding the up or down buttons will rapidly, advance through the channels. Up Button Down Button Call Button Call Signals When the call button is pressed, the FR-114-2 will transmit a threesecond ringing sound to other transceiver's tuned to the same channel. This feature can be used to signal other parties that voice communication is desired. -9- To Transmit 1. Press and hold the Push-to-Talk Button (PTT) button while speaking slowly and clearly in a normal voice, approximately 2 to 3 inches from the microphone. A built-in modulation control circuit will automatically adjust the microphone input level. Release the Push-to-Talk Button (PTT) button when you finish speaking to receive incoming signals. Adjust the POWER ON /OFF-VOLUME CONTROL clockwise to increase the listening volume to the desired level. The transceiver will play strong received signals through its internal speaker or through a headset if so equipped. Monitor Function The monitor button can be used to listen to all signals present on a channel. This is useful when communicating with other parties at extreme range. -10- WARNING n Remove the batteries from the transceiver if it is not expected to be used for long periods. This will eliminate the possibility of battery acid leaking from the batteries and corroding the transceiver. n Do not use this device in or near a mining facility, which uses remotely triggered explosives or in areas labeled "Blasting Area". [. . . ] dated bill of sale), specification of defect(s), transportation prepaid, to the warranty center at the address shown below. The Company disclaims liability for communications range of this product. This Warranty does not apply to any product or part thereof which, in the opinion of the Company, has suffered or been damaged through alteration, improper installation, mishandling, misuse, neglect, accident, or by removal or defacement of the factory serial number/bar code label(s). THE EXTENT OF THE COMPANY'S LIABILITY UNDER THIS WARRANTY IS LIMITED TO THE REPAIR OR REPLACEMENT PROVIDED ABOVE AND, IN NO EVENT, SHALL THE COMPANY'S LIABILITY EXCEED THE PURCHASE PRICE PAID BY PURCHASER FOR THE PRODUCT. [. . . ]