User manual AUDIOVOX FP1510

[. . . ] Traffic The Driver should never operate these products while the vehicle is in motion!Installation of all TV monitors must be out of the driver´s field of vision. Build-in position Installation of all TV monitors must be out of the driver´s field vision. [. . . ] Build-in position Installation of all TV monitors must be out of the driver´s field vision. Make sure to keep products away from direct sunlight at the build in position. Do not mount the product where it will obstruct the development of the airbag or in an area where it would affect the vehicular control. Also be careful to avoid mounting the product, where it can become hazadous during stops or in the event of an accident. Installation Quality installations are best performed by qualifield and certified installers. Cleaning the screen Use only a damp cloth to clean the screen and use purified water on the cloth wiring out all excess water prior to wiping the screen. Liquids If there is any liquid on these products, pull your vehicle to the roadside and turn the key off to disconnect or wipe the products with a towel. Do not operate the equipment until all liquids habe either evaporated or you have the monitor was inspected at the service center by a qualified technican. The Audio / Video output of the monitor control box can be used if you install a second monitor in the car. Be sure the VCD or DVD is working, the monitor will display the normal photo then, this main unit will distinguish automatically from the model PAL and NTSC video signal. Using the remote conrol you can adjust the brightness, color and contrast. The monitor included a built in IR headphone transmitter which allows the use of wireless headphone. The remote control button V1/V2 allow to switch between the booth input sources. remote control button, offer you a quik access to pre adjusted picture settings. Otherwise a manual picture adjustment is possible with the brightness / color and contrast ratio buttons of the remote control. 17 Trouble Shooting Power This product is designed for operation with a 12 Volt DC, negative ground vehicle. Service Do not try and service these products yourself, seel only a qualified service center or factory service center. [. . . ] Otherwise a manual picture adjustment is possible with the brightness / color and contrast ratio buttons of the remote control. 17 Trouble Shooting Power This product is designed for operation with a 12 Volt DC, negative ground vehicle. Service Do not try and service these products yourself, seel only a qualified service center or factory service center. Damages Be careful not to drop or apply undue pressure to the frontpanel of your video monitor. [. . . ]