User manual AUDIOVOX FDK606A

[. . . ] Burn Up To 1500 MP3 and WMA Files onto a DVD+R /RW · Heat Management System - Forced Air Cooling to keep the chip sets operating at nominal temperatures · Subject to technical changes " Before accessing any navigation features, you must purchase and install the NAV module. all installation and operating instructions will be included with the NAV navigation module. Once the NAV is connected and operating properly, the NAV source mode will become active. While the NAV is not installed, the NAV option appears gray, indicating the function is not available. [. . . ] Press the SRC button (6) on the front panel or the SRC button (8) on the remote to change between available playing sources in the following order: AM/FM/RDS, DISC, AUX1, AUX2 and CAMERA (Navigation can be selected if connected). To increase or decrease the volume level, turn the rotary encoder (5) on the front panel or press the VOL+/ VOL buttons (15, 16) on the remote control. When the volume level reaches "0" or "40", a beep sounds, indicating that the adjustment limit has been reached. The Audio Control feature allows you to easily adjust your audio system to meet the acoustical characteristics of your vehicle, which vary depending on the type of vehicle and its measurements. proper setting of the Fader and Balance boosts the effects of the cabin equalizer. Press the AUDIO button (5) on the front panel once to display the audio menu. Adjustment option User Rock Hip Hop Dance Latin Rave Urban Acoustic Adjustment of Bass/Mid/Treble seperately available By push at the "EQ"-field you can choose between the pre adjusted EQ´s By push at the gridfield you can adjust the Fader/Balance accordingly. NOTE: The EQ mode will automatically change to "USER" when individual EQ bands are adjusted. The Audio menu will automatically exit after a few seconds of inactivity. To exit quickly, touch the top left corner of the screen or press and hold the AUDIO button (5). To correct a system halt or other illegal operation, use the tip of a pen to press the reset button (10 ) located on the front bottom-right corner of the unit. NOTE: DVD-R and DVD-RW will not play unless the recording session is finalized and the DVD is closed. To switch to DVD mode when a disc is already inserted, press the SRC button (6) on the front panel or remote control (8) until "DISC" appears at the bottom of the screen. Subject to technical changes Press the << button (22) on the remote control or the << button on the screen to play the current title in slow motion. Keep pressing and releasing the button to increase the rate from "2X" to "4X", "8X", and "20X". Press >/|| (18) on the remote control or touch the onscreen play button (>) to resume normal play. Keep pressing and releasing the button to increase the rate from "2X" to "4X", "8X", and "20X". Press >/|| (18) on the remote control or touch the onscreen play button (>) to resume normal play. VCD (PBC Off): Repeat Single, Repeat Off button on screen to alter repeat mode according to the NOTE: For VCD play, the repeat function is not available if PBC is on. Press the RPT A-B button again once you reach the desired end point (B) of the repeated section. Press the RPT A-B button again to cancel the A-B section setting and stop repeat play. NOTE: When a VCD is playing with PBC turned "On", activating random playback automatically turns PBC off. [. . . ] Playing MP3/WMA Files After inserting a MP3/WMA disc, files will play in the sequence of the "Root' directory. NOTE: When burning MP3 / WMA files onto a DVD disc, use the 2X or 4X burning option, if available. This slower burning speed will help eliminate buffer errors and increase disc reading reliability. Also, use folders when burning large numbers of songs / files to a disc for easy music navigation. [. . . ]