User manual AUDIOVOX CE156MP

[. . . ] · Do not mix ALKALINE, standard (CARBON-ZINC) or rechargeable (NICKEL-CADMIUM) batteries. Notes on headphones / earphones Do not use headphones / earphones while driving, cycling, or operating any motorized vehicle, it may create a traffic hazard and is illegal in some areas. It can also be potentially dangerous to play your headsets at high volume while walking, especially at pedestrian crossings. You should exercise extreme caution or discontinue use in potentially hazardous situations. If you experience a ringing in your ears, reduce volume or discontinue use. [. . . ] The CLASS LASER PRODUCT label is located on the bottom exterior. PLAY MODE BUTTON It changes playing mode as follows: Repeat One -> Repeat All -> INTRO -> SHUFF -> SHUFF All -> PROGRAM BUTTON It reserves songs to play in the program play mode. EQ BUTTON It changes EQ mode in play mode as below: Normal -> Bass -> Train -> Live -> POP -> Jazz STOP BUTTON It activates stop mode from playing mode, activates standby mode. SKIP/SEARCH BUTTON It activates skip to previous track (or directory) and activates high-speed reverse search. VOLUME BUTTONS Adjust the volume. ESP ON/OFF BUTTON (For CD playback only) It activates/deactivates ESP functions by pressing ESP ON/OFF button. (Prevent sound skipping) DIR To search a file by directory level for MP3 disc. PLAY/PAUSE BUTTON It release standby mode, playing starts from stop mode. SKIP/SEARCH BUTTON It activates skip to next track (or directory) and activates highspeed forward search. OPEN KNOB For opening the CD door. For the Customers in Canada This apparatus complies with the Class B limits for radio noise emissions set out in radio interference regulations. This product contains a low power laser device. CLASS 1 LASER PRODUCT APPAREIL À LASER DE CLASSE 1 PRODUCTO LASER DE CLASE 1 PRODUTO LASER CLASSE 1 DO NOT TOUCH THE LENS CAUTION: INVISIBLE LASER RADIATION WHEN OPEN AND INTER LOCKS DEFEATED AVOID EXPOSURE TO BEAM PRECAUTIONS On safety As the laser beam used in this compact disc player may be harmful to the eyes, do not attempt to disassemble the casing. Do not put any foreign objects in the safety slot inside the disc compartment. Do not put any foreign objects in the DC in 6V (external power input) jack. Should any solid objects or liquid fall into the unit, disconnect the power supply and have the unit checked by qualified personnel before operating it any further. On operation Since the CD system offers a wide dynamic range, the peaks of the high level inputs are recorded with high fidelity, and the noise level is very low. Do not turn up the volume while listening to a part of the disc with no audio signals or very low level inputs. If you do so, the speakers may be damaged when the peak level of the sound is played. If you do so, the lens may be damaged and the unit will not operate properly. Notes: · The normal function of the product may be disturbed by interference and shows error message, just reconnect the power source for resume normal operation. · The CD player and adaptor shall not be exposed to dripping or splashing water and that no objects filled with liquids, such as vases, shall be placed on the apparatus. Note: The key tone will be heard while pressing the function buttons. DISC PLAYING 1. Insert the CD with the printed side facing upwards and push the disc gently until it clicks so that the disc fits into the pivot. Press the " " button to play. On display windows When you press " " , the display window shows: On installation Never install the unit where it would be subject to: - heat sources such as radiators or airducts. - uneven surface. During play The track number of the current selection appears. When " " is pressed during play, total number of tracks on the disc will be displayed and the unit is still on. The unit will return to full stop mode automatically after approximately 30 seconds if no button is pressed again. [. . . ] In stop mode, press the PROGRAM button, "000" will appear in the display window and flash. Press the " " button to start play and " PROG " shows in the display window. " To Edit Program Play: To check: Press PROGRAM button lightly during programming before you press " ". Each time the PROGRAM button is pressed until the program number appears in the display window. [. . . ]