User manual AUDIOVOX BMS58

[. . . ] Follow the diagram below for installation satellite antenna Satellite A Inputs Antenna CATV Satellite B Inputs DC power (RG6 cable not included) television ground screw To satellite receivers satellite receiver Connect up to eight receivers diplexer* The TERK 5x8 Multiswitch works as a diplexer, combining your satellite and TV antenna (or cable) signal. [. . . ] (TERK) warrants this product against defects in materials or workmanship for one (1) year from the date of purchase. During this warranty period, this product will be replaced without charge. This warranty does not cover any damage due to acts of nature, commercial use, accident, misuse, abuse or negligence. Replacement as provided under this warranty is the exclusive remedy of the consumer. TERK shall not be liable for any incidental or consequential damages for breach of any express or implied warranty on this product, except to the extent that limitations of this sort are prohibited by applicable law. THERE ARE NO IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURCHASE EXCEPT TO THE EXTENT THAT IMPLIED WARRANTIES OF EITHER SORT ARE REQUIRED BY APPLICABLE LAW, AND IN SUCH CASE, EACH WARRANTY IS LIMITED IN DURATION TO ONE YEAR. * When connecting an antenna or cable signal to the multiswitch you'll need a TERK diplexer (BDS-P1) at each satellite receiver to separate the signal back to TV antenna (or cable) and satellite. [. . . ] Conveniently only 1 wire goes to each location! Specs:: For Indoor and Outdoor use: Input Frequency Range: Output Frequency Range: Insertion Loss: Noise Figure: Cross Polar Isolation: Current Consumption: Power Adapter: 22KHz Tone Output: 950 - 2150MHz 54 - 806MHz (UHF/VHF) 54 - 2150MHz (Each Output) -5dB 54 - 806MHz 0dB 950 - 2150MHz 4. 8dB min 30dB min 60mA 120 VAC 60Hz Input 24 VDC 1A Output 22 + 4KHz continuous, 650 + 300 mVp-p [. . . ]