User manual AUDIOVOX AVT-1940

[. . . ] UDIOVOX PECIALIZED PPLICATIONS, L. L. C. INSTRUCTION MANUAL 19" COLOR TELEVISION AVT-1940 The serial number is located on the rear of the set. Serial No. ________________________________ CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE RISK OF ELECTRIC SHOCK, NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL. The lightning flash with the arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated "dangerous voltage" within the products enclosure that may be of sufficient magnitude to constitute a risk of electric shock. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and servicing instructions in the literature accompanying the product. [. . . ] See the section, "Programming Your TV's Channel Memory" on the previous page. The number buttons (0-9) will take you to any channel, even if it has not been memorized. To change to a channel enter it's number: the TV will tune to the new channel when you enter the second digit of the channel. The PREVIOUS button will take you instantly to the last channel you were watching. Changing the Volume 1. To change the volume of the TV set, use the ÿ VOL ÷ buttons on the remote or on the front panel. To return the volume to its previous level, press MUTE again. Chapter 3: Operating your TV- 11 Changing the TV's Channel Memory Your TV's channel determines the channels that are available using the ù CH ü buttons. If a channel is removed from memory you can tune to it with the ù CH ü buttons. If there is just one channel memorized, then the Add/Delete Channels function will search the whole channels. But if there are two or more channels memorized, then the Add/Delete Channels function will search the memorized channels only. Press the MENU button twice, then "Set Up" menu will display. Use the ù CH ü buttons to select "Add/Delete Channels", then use the ÿ VOL ÷ button to enter the Add/Delete Channels" process. If the channel is not in memory, then use the ÿ VOL ÷ button to delete the channel from memory. If the channel is in memory, then use the ÿ VOL ÷ button to delete the channel from memory. If you are going to delete another channel, press the ùCH ü buttons until desired channel is selected. Wait 10 seconds or press the MENU button four times to ex Displaying the Current Channel 1. To quickly see the current channel number and status, press DISPLAY button on the remote control The current channel number and status will be displayed. 12- Chapter 3: Operating Your TV Adjusting Video Settings You may wish to adjust the video settings (e. g. With the TV on, press the MENU button, then the "video" menu will appear. Use the ÿ VOL ÷ buttons to turn Settings to Preset or Custom. Use the ù CH ü buttons to select the video settings you wish to adjust. Use the ÿ VOL ÷ buttons to adjust the video setting to the level you prefer. Use the ù CH ü buttons to select another video setting to adjust. When you are finished, press the MENU button until OSD will disappear. Chapter 3: Operating Your TV-13 Returning to the Factory Settings If you would like to return to the original video settings, as they were calibrated at the factory, follow these steps: 1. [. . . ] · Check that the antenna is connected, is in good working order, has no broken wires and is adjusted correctly. · Check that the antenna is connected, is in good working order, has no broken wires and is adjusted correctly. You can not tune to a cable channel · Make sure that the AIR/CABLE setting is correct. The picture rolls, slants, shows lines, is grainy, has poor color or has ghosts. [. . . ]