User manual AUDIOVOX AS94954P

[. . . ] INSTALLA ALLATION INSTALLATION GUIDE FOR THE: STAGE TWO STAGE INFRASONIC SHOCK SENSOR AS-9495-4P (NR) Taiwan Printed In Taiwan Form No. [. . . ] Mount the sensor using the two screws provided or cable ties securing it to your chosen location. CONNECTING THE SENSOR: 1. Connect the large 4 pin connector of the wiring harness to the 4 pin mating connector on the AS-9495-4P (NR). Route the small 4 pin connector of the harness toward the alarm control module and connect it to the mating 4 pin connector on the alarm unit. SENSITIVITY ADJUSTING: Note: The shock sensor's LED's will not operate unless the alarm system is armed. The sensitivity of the pre-detect stage, (indicated by the Red LED flashing rapidly), and full trigger stage, (indicated by the Red LED turning on momentarily) are set with one setting. The pre-detect stage will operate at 30% less freta tefl tigrsae oc hn h ul rge tg. Arm your alarm system than firmly strike the windshield pillar with the open palm of the hand considering the force required to break the vehicle glass. If the alarm system triggers easily, disarm your alarm, turn the adjustment screw located on the sensor counterclockwise to decrease the units sensitivity, and repeat the above test. If the siren emitted a few short bursts (pre-detect) no further adjustment is necessary. [. . . ] Keeping your settings at a minimum will prevent these problems. MODE L AS -949 5-4P Pre-Detect and Trigger Full Trigger LED To Mating Connector On Alarm [. . . ]