User manual AUDIOVOX APS-905

[. . . ] REMOTE STARTING THE VEHICLE The system will not start the vehicle if any one of the following situations exists; The vehicle's hood lid is opened. To start the vehicle, press and release the Trunk/Key button two times within 2 seconds. The vehicle will start and remain running for the pre-programmed 5, 10, 15, 20 minute run cycle. As a visual indication, the parking lights will flash or remain on depending on the setting by your installation center. [. . . ] Page Call Out: (only available on certain models) From within the vehicle, if the valet push button is pressed for three seconds, the alarm unit in the vehicle will transmit to the LCD remote and a beep tone will be heard and a phone icon on the hand held transmitter will flash indicating that someone is calling you to the vehicle. Your transmitter has a battery indicator that is shown in the upper right corner of the screen as shown below. Replace battery with a fresh 1. 5V AAA battery and dispose of the used battery properly. Other icons that will be displayed at times when certain functions and features are active in the vehicle or on the remote: Range Indicator. The range indicator will have bars to the side of the icon if the unit is out of range. Vibrate Mode On, this icon will be displayed if you select vibrate instead of tones. Locate vibrate/tone select in the transmitter program section and set for vibrate. This icon will be toggled on and off when the "F" + Trunk/Key buttons are pressed simultaneously. The feature must be set in the feature selection menu of the transmitter. This icon is toggled on and off by pressing the "F" + Option buttons simultaneously. The feature must be set for a time in the feature selection menu of the transmitter. The transmitter has a built in timer that can count down from 10, 20, 30, 60, 90, or 120 minutes. This feature is useful when parking the vehicle in a metered parking lot. If the time on the parking meter is 30 minutes, you can set the count down timer to 20 minutes. The transmitter will emit a beep tone when the timer expires to remind you to get back to your vehicle. To use the parking meter timer, Press the "F" + Option buttons more than one time. Activating the "F" + Option a second time will set the parking meter count down to 10 minutes, a third time will set it to 20 minutes, a fourth time will set it to 30 minutes, etc. . . up to 120 minutes, then the cycle will repeat, countdown activation, 10 minutes, 20 minutes and so on. Once you stop at a setting, the unit will count down and when it reaches the set time will alert you with a beep tone as a reminder that you have to get back to the vehicle. Other available options access and Icons that may be displayed on your two way transmitter: Check Vehicle Status: Press the lock+key+option buttons simultaneously for 1 second. Light The Display: Press and release the "F" (Function) button one time. Daily Start Timer: (Only available on certain remote start units) Press the option+lock buttons simultaneously for 1 second. [. . . ] With the turbo timer mode selected on, after you've arrived at your destination, while the engine is still running, set the parking brake, pause 2 seconds, then turn the ignition switch to the off position. The engine will continue to run the allotted time according to the selection during installation. If you do not want the vehicle to continue to run for one cycle, simply step on the vehicle's brake, or release the parking brake, or activate the transmitter's start button two times in succession. SAFETY CONTROL SWITCH The red handle control switch allows you to temporarily disable the remote starting function of the system and moving this switch to the Off position is recommended whenever the vehicle is being serviced. [. . . ]