User manual AUDIOVOX AOM-78

[. . . ] This warranty does not extend to the elimination of externally generated static or noise, to the correction of antenna problems, to costs incurred for removal or reinstallation of the product, or to damage to any tapes, speakers, accessories, or electrical systems. This warranty does not apply to any product or part thereof which, in the opinion of the company, has been damaged through alteration, improper installation, mishandling, misuse, neglect, or accident. THE EXTENT OF THE COMPANY'S LIABILITY UNDER THIS WARRANTY IS LIMITED TO THE REPAIR OR REPLACEMENT PROVIDED ABOVE, AND, IN NO EVENT, SHALL THE COMPANY'S LIABILITY EXCEED THE PURCHASE PRICE PAID BY THE PURCHASER FOR THE PRODUCT. This warranty is in lieu of all other express warranties or liabilities. [. . . ] BY - Monitor operates when vehicle transmission is switched into " REVERSE ". ON - Monitor and system operate when ignition switch is " ON ". * MONITOR FRONT VIEW 2. Input switch " A " used mainly for rear mounted camera or as specified by the installer. " B " used mainly for side or mirror mounted camera or as specified by the installer. Day / Night switch Pre-set brightness and contrast levels optimized for day and night operation. POWER A B INPUT DAY/NIGHT 4. Should be adjusted if the " DAY / NIGHT " switch does not achieve the most desirable picture. Should be adjusted if the " DAY / NIGHT " switch does not achieve the most desirable picture. Volume Variable control of internal speaker and external speaker volume. + + + Rear of Monitor 1. Power connection : Pin 1 not used Pin 2 Ground - black wire Pin 3 Reverse circuit - blue wire Pin 4 not used Pin 5 battery backup - yellow wire Pin 6 + 12VDC ignition - red wire 2. External speaker connection center pin is positive audio output, used to disable the internal speaker and remotely mount a speaker for driver convenience. * MONITOR BACK VIEW MODEL : AOM-78 POWER SOURCE : DC11V~30V OUTPUT POWER : MAX 22W MADE IN MALAYSIA EXT SPKR CA1 CA2 POWER MONITOR OPERATING CONTROLS AND CONNECTIONS 3 4 MONITOR MOUNTING HOLE PATTERN 5-0. 236 DIA HOLES INSTALLATION INSTRUCTIONS AOM-78 MONITOR 1. Attach monitor inside vehicle in a location convenient to the driver (e. g. Use a compression plate to attach the monitor bracket to the dash or overhead (See Fig. Adjust mounting angle of the monitor to allow driver to easily view the screen from all seat position (See Fig. Press all (4) sides of the visor to snap it into place. DASHBOARD OR OVERHEAD ** CAUTION ** 1. Keep all cables away from HOT, ROTATING and ELECTRICALLY NOISY components. To increase protection of cable, place all excess wire and extension cable in convoluted tubing. Do not twist camera cable and do not cut camera pigtail or cable. STEEL PLATE FOR REINFORCEMENT (RECOMMENDED FOR SECURE MOUNTING) SPRING WASHER PLAIN WASHER MAINTENANCE : Remove dust and dirt with a damp soft cloth. Heavier dirt should be removed with a damp soft cloth and mild detergent. Do not use strong cleaning agents containing gasoline, thinner, benzene or alcohol. These substance may damage the exterior surface of the monitor. 110. 0 5 6 FIGURE 1 FIGURE 2 5. 275 7. 665 ** WARNING ** 1. [. . . ] The red wire marked ACC is connected to an ignition power source, the black wire marked GND is connected to chassis ground, and the blue wire marked BACK is connected to the vehicle's back up circuit. AFFIXING DISTANCE MARKERS TO THE MONITOR SCREEN 1. Place distance indicators behind the vehicle at (3) feet, (5) feet and (9) feet along the width of the vehicle. Attach the markers to the monitor screen over the images of the distance indicators. These markers represent a distance of (3) feet, (6) feet and (9) feet from the back of the vehicle. [. . . ]